enphase Thermostat Quick Start Manual
ENPHASE QUICKSTART GUIDE
4 Easy Steps
1
REGISTER
Installers: Begin the activation process
• Log in to: enlighten.enphaseenergy.com/register and complete the form.
• First-time installers: Go to enlighten.enphaseenergy.com/register and complete
the form. Your login credentials will be sent to you.
• Self-installers: Click on the “Self-installed” checkbox.
• Existing installers: Log into Enlighten, click “Activations” and then “Add New System”
(If you are not sure your company is registered, contact Enphase support to find out)
For guidance on how to use the Array Builder, please visit
1 2 3
www.enphaseenergy.com/learningcenter
1 2 3
BROADBAND ROUTER
LAN CABLE
9800000 00366-B 9800000 00364-B
2
INSTALL
Install the PV modules and microinverters
Consult the microinverter installation guide for more details.
3
CONNECT
Install the Envoy Communications Gateway
• Connect to a broadband router and plug into a dedicated wall outlet.
• Wait 15 minutes to allow the Envoy to scan all the microinverters in your array.
• Ensure at least 2 level bars and the correct number of microinverters are showing
(see overleaf for troubleshooting).
05:00 +WEB
LEVEL
4
Devices: 15
ASSIGN
9800000 00364-B 9800000 00362-B 980000000367-B
Use the Array Builder to generate the array
Once all microinverters have been detected, log in to Enlighten to
use the Enlighten Array Builder.
support@enphaseenergy.com
1 877 797 4743
Solar PV power systems should be
installed by qualified personnel.
TROUBLESHOOTING
If… Then…
05:00 –WEB
LEVEL
Devices: 15
You see –WEB instead of +WEB
05:00 +WEB
LEVEL
Devices: 15
You have zero or one bars for level
LEVEL Devices: 15
LEVEL
05:00 +WEB
Devices: 10
The number of devices shown is less than
the number of microinverters installed
Reboot the Envoy (i.e. turn it off and then
on again) and wait for at least 15 minutes.
Relocate the Envoy to the power outlet closest
to the load center (and contact Enphase to
receive a free pair of Ethernet bridges within
3 business days to connect the Envoy back to
the internet router).
If the number of bars is zero or one, relocate
the Envoy to the power outlet closest to the
load center (and contact Enphase to receive a
free pair of Ethernet bridges within 3 business
days to connect the Envoy back to the internet
router).
If the number of bars is more than two, please
contact Enphase for further troubleshooting
assistance.
ENVIRON SMART THERMOSTAT INSTALLATION
If you have purchased the Enphase Environ Smart
Thermostat, please follow the additional instructions below
after the solar installation is completed and the Envoy
Communications Gateway is installed:
TOOL LIST
Phillips screwdriver
STEPS
1 Power off the HVAC system.
2 Remove existing thermostat off the wall.
3 Connect the correct HVAC wires to Environ, then mount the Environ to wall.
4 Plug the Zigbee (wireless) USB stick into Envoy, confirm the Envoy's detection of
the Environ smart thermostat.
5 Log in to Enlighten to program the Environ with the desired heating/cooling settings.
support@enphaseenergy.com
1 877 797 4743
Environ
72.5
For training on the Environ
Smart Thermostat, please visit
www.enphaseenergy.com/events
140-00023 Rev 02
Loading...