enphase Enboy R, Envoy R Standard, Envoy S Metered Connecting Manual
Connecting an Envoy to the Internet
Envoy R Wi-Fi Adapter
Envoy S – Standard Envoy S – Metered
1
Contents
Wired Connection ......................................................................................................................................... 3
Envoy R ...................................................................................................................................................... 3
Envoy S ...................................................................................................................................................... 3
Wireless Connection ..................................................................................................................................... 3
WPS Method (All Envoy Models) .............................................................................................................. 3
Method A for Envoy R – Manual Configuration for Internet Connection ................................................. 4
Method B for Envoy R – Manual Configuration for Internet Connection ................................................. 9
Method C for Envoy S – Manual Configuration for Internet Connection ............................................... 10
Method D for Envoy S – Manual Configuration for Internet Connection ............................................... 14
2
Wired Connection
IMPORTANT – When connecting your Ethernet cable into the modem, ensure you plug the cable into a
LAN port (not the WAN port).
Envoy R
Using an ethernet cable, connect the Envoy R to your router/modem and wait up to 5 minutes. If
successful the IP address will change to an address that begins with either 192, 172 or 10, and you
should also see “+Web” in the top right corner.
Envoy S
Using an ethernet cable, connect the Envoy S to your router/modem and wait up to 5 minutes. The very
top LED (next to the cloud icon) will begin flashing green initially to indicate that the Envoy S is
attempting to establish a connection to the Internet. If successful, the top LED will become solid green.
Wireless Connection
WPS Method (All Envoy Models)
The WPS method is the easiest and quickest method to connect an Envoy to the Internet. Therefore, it is
recommended to attempt this first as it will only take a few minutes.
Envoy R
Note – The Wi-Fi adapter needs to be plugged into
the Envoy R in order for this to work
1) Hold down the MENU button until “Enable Wi-Fi
WPS” appears on the screen. Release the MENU
button to select it.
2) Push the WPS button on your router.
3) Wait up to 5 mins.
4) If the Envoy screen shows +Web then the internet
connection was successful.
Envoy S
1) Hold the top button for 5 seconds (the button beneath the phone icon and above the lightning bolt
icon).
2) The top LED (next to the cloud icon) will begin to flash green to indicate WPS mode is activated.
3) Push the WPS button on your router.
4) Wait up to 5 mins.
5) If the top LED becomes solid green, internet connection is successful.
3
Method A for Envoy R – Manual Configuration for Internet Connection
NOTE – The Wi-Fi adapter must be plugged into the Envoy, otherwise step 1 will not work
1) Holding down the MENU button, wait until the 7th option “Enable Wi-Fi AP” appears on the screen,
then release the MENU button to select it (the message “Wi-Fi AP Enabled” should appear on the screen
briefly).
2) On a smartphone/tablet/laptop/computer (any device that is able to connect to a Wi-Fi network),
connect to the Envoy’s Wi-Fi network (ENVOY_xxxxxx where “xxxxxx” represents the last 6 digits of the
Envoy serial number).
3) Open up any web browser application (eg. Safari, Internet Explorer, Google Chrome), type into the
address bar “172.30.1.1” and press enter.
4
4) The Enphase Envoy page should appear; click on the Administration tab.
5) When prompted for a login, the username is "admin" and the password is also "admin" (not including
the quotation marks).
6) A grey menu should appear on the left; click on "Wi-Fi Configuration".
5
Loading...