EnOcean USB 300, USB 400J, USB 500U User Manual
USB 300 / USB 400J / USB 500
ENOCEAN USB GATEWAY
© 2020 EnOcean | www.enocean.com USB 300 / USB 400J / USB 500U Installation Guide | November 2020 | Page 1/4
Features Overview
Frequency/modulation
USB 300: 868.300 MHz / ASK1)
USB 400J: 928.350 MHz / FSK
1)
USB 500U: 902.875 MHz / FSK
1)
Data rate
125 kbit / s
Antenna
PCB antenna
Receiver sensitivity (at 25°C)
2)
USB 300: typ. –96 dBm
2)
USB 500U: typ. -98 dBm2)
USB 400J: typ. -95 dBm2)
Receiver category (RED, EN 300 220)
Class 2 (standard performance)
Output power (at antenna base)
USB 300: max. 6.7 dBm
USB 400J: typ. 0 dBm)
USB 500U: typ. 1 dBm)
Dimensions (incl. cap)
70 x 23 x 9 mm
OEM label size
39 x 12 mm
USB interface
Virtual COM port (FTDI)
USB connector
Typ A
Operating temperature
-20°C to +50°C (max. 90% r.h.)
Radio regulations
USB 300: RED (EU)
USB 500U: FCC (US) / ISED (CA)
USB 400J: ARIB (Japan)
1) According to ISO/IEC 14543-3-1x
2) 0.1% telegram error rate (based on the combination of 3 received sub-telegrams).
USB extension cable is recommended for best performance.
Installation Guide
Product Description
USB 300, USB 400J and USB 500U are EnOcean transceivers
providing a bi-directional USB interface for connection to
PC’s, Wi-Fi access points or IoT gateways.
Windows PC installation
Plug USB stick into USB port of PC or notebook
Download and install DolphinView:
https://www.enocean.com/en/support/download/
Start DolphinView and press connect button (F5)
Gateway/Wifi access point installation
Plug USB stick into USB port of gateway or Wifi access point
Follow instructions of gateway or Wifi access point documentation
Technical information
USB 300, USB 400J and USB 500U provide the following key features:
Reception and transmission of radio telegrams according to EnOcean Radio Protocol
Serial interface over USB (Virtual COM port) according to EnOcean Serial Protocol v3
Power status LED (green) and USB communication activity LED (yellow)
Ordering information
Product
Frequency
Order Number
Tray/Bulk Package OEM
Order Number
Single Product Package
USB 300
868.300 MHz
S3004-K300
E3004-K300
USB 400J
928.350 MHz
S3064-K400
E3064-K400
USB 500U
902.875 MHz
S3054-K500
E3054-K500
USB 300 / USB 400J / USB 500
ENOCEAN USB GATEWAY
© 2020 EnOcean | www.enocean.com USB 300 / USB 400J / USB 500U Installation Guide | November 2020 | Page 2/4
Troubleshooting
In order to optimize radio performance and minimize radiated noise from connected
computer equipment we strongly recommend using an USB extension cable
For advanced development and analysis, we recommend using EnOcean Developer Kit
The USB stick front cap is used as handling protection during delivery.
In case of installation issues, check LEDs:
* USB stick powered by USB port -> green LED on
* Radio telegram received or sent -> yellow LED short flash
Agency certifications
Hereby, EnOcean GmbH declares that this radio equipment is in compliance with the essential requirements and other relevant provisions of the European Union. A copy of the Declaration of Conformity can be obtained from the product webpage at www.enocean.com
The WEEE marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. Germany: WEEE-Reg-No.: DE 93770561
contains: FCC: SZV-TCM515U
IC: 5713A-TCM515U
This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
TCM 410J used in USB 410J complies with the Japanese radio law and
is certified according to ARIB STD-T108.
When the product is placed on the Japanese market, it must carry the Specified Radio Equipment marking as shown to the left. If the certification label cannot be recognized from outside
(e.g. installation in a host) then the appropriate information must be referenced in the user
manual.
Loading...