Enlux EL-300 Quick Install Manual

EL-300

Quick Install Guide

Micro Inverter

8F., No.328, Changchun Rd., Zhongshan Dist.,Taipei City 104,Taiwan (R.O.C.)

Tel: [phone] Fax: [phone]

Before Installation

Please make sure the operation voltage and operation current are within EL-300 micro
inverter ’s supporting range.

Please do NOT connect over 12pcs EL-300 micro inverter in one circuit string.

Please record the serial number of the micro inverter installed by using the system map.
This information is required for registration to Envision monitoring.

Grounding

Install grounding hardware and attach a grounding wire.
Use a recommended grounding lug with a continuous
grounding wire to ground the system.

Grounding wire

Preparation

1

Take EL-300 micro inverter out of the box.
You will find the serial number label in the front side.

Peel the serial number labels from each EL-300
micro inverter.

Affix the serial number labels to the System Map.

Attach EL-300 Micro Inverters to the PV Racking

2

Mount the EL-300 micro inverters under PV modules.

Install mounting hardware

Torque ground clamp screw by 5 Nm torque for 6mm screw or 9Nm torque for 8mm screw.

Serial number label