ENJI PRIME EyeBall Cam Quick Start Manual

EyeBall Camera

1080P Mini Wifi Spy Camera

Quick Start Guide

Enji EyeBall Cam

1080P Mini Wifi Spy Camera
This manual describes how to use a 1080P Enji EyeBall

Mini Hidden Spy Camera and install the supplied software.
Be sure that you have read and understood its contents
before using the camera.

To get started, you need:

1. A wireless router, its network name, and password if
necessary. (NOTE: Router accepts only 2.4 Ghz. Use

numbers and letters in creating network name and
password.)

2. A smart device, such as an Android Smart Phone or
Tablet (Android version 4.0 or latest) or an iPhone, iPad,
or iPod Touch (iOS version 6.1 or later).

PARTS & CONTROLS

CHARGING

Before use, fully charge the built-in rechargeable lithium
battery first for about 2 hours. The camera works even while
charging.

Notes:

Red LED light is on while charging, once fully charged, red
LED light turns off. If image is not clear, this means the
battery is low. Charge the battery first for 2 - 3 hours. Battery
life is about 60 minutes.

POWER ON / POWER OFF

Press ON/OFF button once to power the camera on.
To power off, press and hold the ON/OFF button for 5
seconds. The red and yellow indicators will turn off .The
Camera is now off.

INDICATORS & MODES

After connecting the battery/charger to the camera, press
the ON/OFF button to power on the camera.

1. Red LED indicates that the camera is charging.

2. P2P(AP) mode: Blue LED lights on, yellow LED flashes
slowly

3. Remote IP Mode: Blue LED lights on, yellow LED
flashes quickly for a few seconds then always stays ON

NOTES:

1. Once you have configured remote IP mode, yellow LED
is lighted and stays ON. Under any mode, the camera
can be reset to P2P Mode.

2. Press the reset key about 5 seconds until all lights go
OFF, if the camera boots up again, reset is successfull
(about 30 seconds).

APP DOWNLOAD

MUCAM

Picture 1

Picture 2

1. Scan the QR (picture 1) code directly to the download
interface (picture 2).

2. Select and download software according to your
mobile phone system.

*You can also download the App “Mu Cam” from Google
Play Store (for Android) or Apple Store (for iOS). Or open
the link to download the APP.

APP Download Link ：

http://112.124.40.254:808/app_dwn/MuCam.html

CONNECTING TO WIFI

P2P Mode Connection (Point to Point)

1. To connect to your smartphone’s hotspot

connection, search for your phone’s WIFI signal

and tap to connect network with the camera UID
(which is unique to each unit), as shown in the
image below:

Please note that when connected to your phone’s hotspot,
camera can’t be controlled remotely when phone’s WIFI

signal is out of camera range. If there is no hotspot Wifi,

please reset the camera.

2. Then Open the phone App (Mu Cam). This signal
is the machines UID which is different for each

machine. Click on the icon “ ” to add into the

camera as shown below: