EnGenius ESR1221N2 Quick Install Guide

Quick Guide

Power On

1. Plug in the adapter to DC-IN jack and wait
about 20 seconds for system to complete its
process.

2. Wireless LED will be fully on when system is
powered up and ready.

Network Setup

3. Make sure your network interface on the PC/Laptop is configured to DHCP (Obtain an
IP address automatically). Please refer to Chapter 2 for setup detail.

Setup

4. Insert Wizard CD into your CD/DVD-ROM drive. Wizard will
automatically start in a few seconds. Should there be any security
prompt, please select allow or accept to proceed.

5. If Wizard does not start, please manually open
the file “index.htm” using your default browser.

6. Please follow the instructions
given by the Wizard on the
screen to complete the setup.

Thank you for choosing EnGenius