Energy cloud PowerCost series Monitor Sensor Installation Manual

Thank-you for purchasing the PowerCost Monitor™ CloudConnector/Sensor.
This product will enable you to better understand your electricity usage and
help you save money. Setting it up is as easy as 1-2-3!

SERIES

(see reverse for a pre-installation checklist of information you will need)

Create or log into your EnergyCloud account at

https://energycloud.powercostmonitor.com

STEP 1:

STEP 2:

The setup wizard will automatically appear. Follow the
steps to setup your CloudConnector. If installing an
additional CloudConnector, select Setup New Device in

Device Settings menu.

STEP 3:

Follow the steps to install your PowerCost Monitor™
Sensor on your electricity meter.

Pre-Installation Checklist

Have the following information ready prior to attempting to setup your PowerCost Monitor CloudConnector and
Sensor. Your home wireless network information is not required if you plan to setup the CloudConnector with a
wired connection.

Wireless Network Name (SSID):

Wireless Network Password:

1.0

You can nd the power factor on the face of your
electricity meter with the prex Kh, Kt or Ks. If you
can’t nd it use 1.0 for now. You can change it later.

Note:

FCC & ISED Information

REQUIRED FOR WIRELESS SETUP ONLY

REQUIRED FOR WIRELESS SETUP ONLY

Electricity Meter Power Factor:

This device complies with FCC Part 15 and Industry Canada license exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device.

Double

Flashing

The PowerCost Monitor CloudConnector is in setup mode.

Connect your computer to the “cc-_......” wireless network,

then open a browser and enter https://192.168.187.1 to
access the setup page.

Slow Flashing

(1 per second)

Fast Flashing

(3 per second)

The PowerCost Monitor CloudConnector is attempting to
connect to your home wireless network.

The PowerCost Monitor CloudConnector is connected
to your network and is attemping to connect to
EnergyCloud.

Solid

O With

Occasional

Flash

P/N: BLI-00462-002

The PowerCost Monitor CloudConnector is connected to
EnergyCloud and is waiting to link with the PowerCost
Monitor Sensor on your meter.

The PowerCost Monitor CloudConnector is operating
normally. Flash occurs each time a meter reading is
received from the PowerCost Monitor Sensor.

CloudConnector Status Indicator

Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.

“Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.”

"Les changements ou modications non expressément approuvés par la
partie responsable de la conformité pourraient annuler l'autorité de
l'utilisateur à utiliser cet équipement."