Energizer ER-IRNANO User Manual

Instructions for Battery Replacement - Apple iPod™ NANO

These instructions come with no warranty or guarantee. Improper assembly or use of excessive force
may result in damage to your iPod™. The buyer assumes full responsibility for damages or problems
caused by use of these instructions. Installing this battery requires a moderate level of technical ability

and proficiency in the use of hand tools as well as a general understanding of electronic components.

Step 1

Before opening your iPod™, ensure that the hold switch is in the locked position.

Step 2

Insert the plastic tool in the seam between the plastic front and metal back of the iPod™. Once
you've inserted the tool, run it along the seam to free the five tabs holding the iPod™ together.

Step 3

Work around the corner of the iPod™ and release the single tab near the hold switch.

Steps 4

After ensuring all tabs are free, separate the two halves of the iPod™.

Step 5

Remove the following 3 screws: Two 3 mm Phillips® screws near the dock connector. One 4
mm Phillips® screw along the edge of the logic board.

Step 6

Peel up the ground strap connecting the battery to the logic board. Rotate the battery out of the
iPod™ and replace it with your new battery.

Step 7

Replace three screws and snap panels back together.

Your new battery will need a minimum of three hours charge time before its first use.