Energetic Lighting E2FMA Series Installation Instructions Manual
LIGHTING
Model # E2FMA series
Flushmount
Ceiling Fixture
Installation Instructions
ATTACH YOUR RECEIPT HERE
Item Number
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-866-492-6566.
Purchase Date
www.energeticlighting.com
1
PACKAGE CONTENTS
A
B
HARDWARE CONTENTS (shown actual size)
AA
Short Screw
Qty. 2
SAFETY INFORMATION
BB
Long Screw
Qty. 2
Part Item Name Qty.
A
Fixture Pan
B
Diuser
CC
Wire Nut
Qty. 3
DD
Crossbar
(Not to scale)
Qty. 1
1
1
SAFETY INFORMATION
NOTICE
•
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and the receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-
Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Phillips Screwdriver
Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.
Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or
•
turn off the circuit breaker.
Changes or modifications not expressly approved by the party responsible for compliance
•
could void the user’s authority to operate the equipment.
CAUTION:
The fixture body is one piece. Do not disassemble it.
•
This fixture is dimmable with most phase-cut triac dimmer switches, for the latest
•
compatibility list, please visit www.energeticlighting.com.
NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
•
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
INSTALLATION INSTRUCTIONS
1. Align two of the threaded holes on crossbar (DD) over
one set of keyhole slots on the fixture pan (A). From
the inside of fixture pan (A), insert long screws (BB)
into aligned holes, leaving about 1 in. of space
between the screw heads and crossbar (DD).
Note: Do not install fixture pan (A) yet.
Hardware Used
BB
DD
Long Screw x 2
Crossbar x 1
1
DD
BB
A
www.energeticlighting.com www.energeticlighting.com
32
Loading...