Energetic Lighting E1ALB Series Installation Instructions Manual

LED Area Light

Installation Instructions

Model # E1ALB series

ATTACH YOUR RECEIPT HERE

Item Number

Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-866-492-6566.

Purchase Date

www.energeticlighting.com

1

PACKAGE CONTENTS

HARDWARE CONTENTS

B

A

Part Item Name Qty.

A

Fixture

B

Diuser (preassembled to xture)

1
1

SAFETY INFORMATION

• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio/TV technician for help.

AA

Wire Nuts

(Qty. 3)

BB

Wood
Screws
(Qty. 3)

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.

• Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or

turn off the circuit breaker.

• Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

• This product must be installed in accordance with local, state and national electrical codes.

• Installation work shall be completed by a licensed installer that is familiar with the

construction and operations of the product.

INSTALLATION INSTRUCTIONS

1. Loosen two outer screws at base of diffuser (B), turn
the entire diffuser so that the screws align with the
large opening of keyhole slot, gently separate and
remove diffuser (B) and set aside.

B

Fig. 1

2. Remove the two screws holding the wiring
compartment cover, set aside cover and screws.

CAUTION:

• The fixture body is one piece. Do not disassemble it.

NOTICE

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

www.energeticlighting.com www.energeticlighting.com

Fig. 2

32