Battery charger for 12 Volt LiFePO4 batteries
C14-10-AY
and
C14-10-AY-SB50
INSTRUCTION, USE
AND
MAINTENANCE MANUAL
Rev. 0 of the 11th December 2014
by
TECNO2 s.r.l. Strada Comunale Cascinotto 139/43, 10156 Torino TO
vendite@tecno2.it Fax +39 011 0708775
ATTENTION !!
This manual is subjected to international copyright laws.
Unauthorized publication of the same whether partial or complete will be persecuted according to
the law. The Company reserves the right to effect modifications and improvements to the
battery charger in any moment and without notice.
LiFePO4 BATTERY CHARGER C14-10-AY and C14-10-AY-SB50 Rev.0
0. HOW TO READ AND USE THIS MANUAL
• This manual must be considered as an integral part of the battery charger.
• This manual must be saved for the entire life span of the battery charger.
• This manual must accompany the battery charger whenever the same is assigned to others.
1. GENERAL INFORMATION
1.1.
GENERAL SAFETY WARNINGS
With reference to the General safety rules, the efficiency of the battery charger must be devolved upon qualified
personnel. The Builder is not responsible for damages occurred to objects or persons if caused from negligence
of personnel that ignore the rules of the present Manual.
ATTENTION: NEVER put in short circuit the poles + and - of the battery charger.
Furthermore, the safety rules calculate the following fundamental points :
• It’s forbidden remove the battery charger shell.
• Do not touch the device in case of wet hands or wet feet.
• Do not pull the power cable in order to disconnect the device from battery.
• Do not expose the device to atmospheric conditions ( rain, sun, etc. )
• During the cleaning of the battery charger it’s compulsory the interruption of all the energies
connected to it.
• The failure of the respect of the instructions for use, the service effected from NOT AUTHORIZED
personnel , declares the warranty NO MORE VALID.
1.2.
IDENTIFICATION DATA
Battery charger identification data are indicated on a plate located on its case.
DISPOSAL:
This product can NOT be considered as simple urban rubbish. This product must be treated from
a separate collection of rubbish centre recognized from the recycling Agency.
1.3.
WARRANTY
The battery charger referred to this Manual, is guaranteed according to the law, effective from the date of
invoice. The Warranty is no more valid if :
• Terms for maintenance not respected
• Damages due to a wrong use , to be more precise functioning limits overcoming (see technical data
schedule )
• Deformation or breakage of the box.
• Opening of the box.
• Routine service or maintenance effected from NOT qualified personnel.
LiFePO4 BATTERY CHARGER C14-10-AY and C14-10-AY-SB50 Rev.0
2. TECHNICAL FEATURES
2.1.
NORMATIVE REFERENCES
ENERGA battery charger is built in compliance with the following laws :
EN61000-3-2; EN61000-4-2; EN61000-4-4; EN61000-4-5; EN61000-4-11; 61000-4-8; CEI EN60950-1
3. CONNECTION AND FUNCTIONING
After the unpacking, check the battery charger in order to exclude possible mechanical damages. Don’t use the
battery charger if damaged. If you are not sure, pls. contact your supplier.
Verify the correct polarity of the whole plant that you will connect. The polarity is indicated on the connector of
the battery through the following symbols :
+
positive
-
negative
The battery charger
C14-10-AY
is quipped with crocodile clip connectors of the following colours :
• RED Positive polarity (+)
• BLACK Negative polarity (-)
Connect the battery charger before to the battery and only after this operation, connect it to the electric socket.
Connect the battery charger RED connector to the positive pole (+) of the battery and the other connector to the
negative pole (-).
The battery charger
C14-10-K-SB50
is quipped with a red Anderson Connector (SB50)
Meaning of the LEDs:
LED 1 - RED : BATTERY CHARGER CONNECTED TO THE MAINS POWER
LDE 2 - RED: ON CHARGE
LDE 2 - GREEN : THE CHARGE IS COMPLETE
C14-10-AY
C14-10-AY-SB50
Input voltage 210 ÷ 240 Vac 210 ÷ 240 Vac
Max input current 1,5 A 1,5 A
Input frequency 50 / 60 Hz 50 / 60 Hz
Output voltage 14,5 V 14,5 V
Charge current 10 A 10 A
Max environmental temperature
40°C 40°C
Weight ( approx. ) 1000 gr 1000 gr
Dimensions ( A x B x H mm ) 175x90x50 175x90x50
Battery connection Crocodile clips Anderson SB50
Loading...