Endura Ultimate Slide Bolt Astragal, Ultimate Lite Astragal Instructions Manual

Ultimate Slide Bolt Astragal

Reversibility Instructions

8817 West Market Street

Colfax, NC 27235 | 800.334.2006

www.enduraproducts.com

Tools Required:

• Chop Saw

• Tape Measure

• Pencil/Marker

• Upper and Lower Trim Caps

• Tail Caps (2)

• Back Pad

STEP 1: REVERSE THE ASTRAGAL

a. Remove upper and lower bolts: Remove the orange

securing pins (two on upper, one on lower bolt) and slide the
bolts out of the astragal. Remove the upper and lower trim
caps and tail cap (if present).

Kit Includes:

Upper Bolt

Lower Bolt

Notes:

• Reverse astragals before cutting
them down.

b. Reverse the astragal: Rotate the astragal so the upper and lower ends are reversed.

1

STEP 2: CUT THE ASTRAGAL BODY FLUSH

NEW BOTTOM OF ASTRAGAL

Cut

Here

a. Using a chop saw, cut the narrow side

of the astragal, so it is ush with the

wide side.

STEP 3: REINSTALL THE UPPER BOLT

NEW TOP OF ASTRAGAL

a. On what is now the top of the astragal,

install the upper trim cap on the wide side
and a tail cap on the narrow side.

b. Return the retracted upper bolt by sliding
back into the astragal body until the end of the

bolt sleeve is ush with the end of the astragal. If
a tail cap is present, the bolt should be ush with

the tail cap.

c. Insert the two orange securing pins into the

bolt in the holes that align with the holes in the
astragal body. (See below if holes are not aligned.)

2Ultimate Slide Bolt Astragal Reversibility Instructions