Endura Ultimate Hurricane Astragal Instructions Manual

Ultimate Hurricane Astragal

Cut Down Instructions

8817 West Market Street

Colfax, NC 27235 | 800.334.2006

www.enduraproducts.com

Tools Required:

• Pencil/Marker

• Tape Measure

• Chop Saw

STEP 1: INITIAL PREPARATION

Notes:

• All cuts should be made from the top of the astragal.

• Ultimate Hurricane Astragals can be cut down a maximum of 7".

Optional Parts:

Tail Cap

a. Remove the two orange securing pins on the
upper bolt. Slide the bolt out of the astragal
and remove.

Ensure the upper bolt is in the unlocked

!

position before removing.

b. Remove the upper trim cap, and tail cap if

present, and set aside.

c. Remove screw from the strike support and
slide the strike support out of the astragal
body.

Rev. Date: 05.07.2018

©2017 Endura Products, Inc.

Innovation protected under patents and patents pending in

U.S. and Canada. See www.EnduraPatents.com.

1

STEP 1 (CONT.): INITIAL PREPARATION

X

STEP 2: CUT ASTRAGAL TO SIZE

d. Measure the length of the door panel and astragal: Measure and

Y

note the height of the door panel (X). Measure the length of the astragal
on the narrow side (Y). The difference (Y-X) will give you the cut down
distance.

IF YOU DO HAVE A TAIL CAP AVAILABLE:

X-9/16"

X-9/16"

Cut Flush

a. Starting at the bottom of the astragal and measuring along the wide side, measure and mark

(X- 9/16") .Cut the astragal ush at this location.

b. Insert the tail cap onto the narrow side of
the astragal body. You may receive two tail
caps, but only one will t.

2Ultimate Hurricane Astragal Cut Down Instructions