Endura TWC1 User Manual
Model: TWC1
FOR RECHARGEABLE LMR BATTERIES
Single Unit Rapid Charger
1
Introduction
Thank you for purchasing an ENDURA™ TWC1, Single Unit Rapid Charger.
This high quality product is designed for use with rechargeable LMR batteries.
With the appropriate charging pod installed, it can charge batteries with:
Lithium ion (Li-Ion), nickel metal hydride (NiMH), or nickel cadmium
(NiCd) chemistry.
For a complete list of charging pods available for this charger, contact your
Power Products dealer or call customer service at 800-529-1618.
Important
Read all Caution statements below and this User Manual before attempting to charge a battery.
Check to make sure a charging pod compatible with your battery is properly installed on charger before placing battery in pod.
Position charger away from TVs, radios, or other receivers to prevent the
charger from interfering with these types of products.
Always charge new batteries completely before initial use. Recycle batteries when they can no longer be used. Do not discard unwanted batteries in the trash or incinerate. Batteries exposed to fire or excessive heat
may explode.
For best battery performance, charge NiCd and NiMH batteries when they
are fully discharged.
■
1.
2.
3.
4.
5.
2
Caution
Never charge alkaline or dry cell batteries with this charger. They may
burst and cause damage or personal injury.
Do not charge Li-Ion, NiMH, or NiCd batteries unless they are designed
with overcharge protection.
Use charger indoors only. Do not expose the charger to rain, any liquids,
or excessive moisture.
Do not attempt to charge a battery without first installing the appropriate
charging pod. Use only charging pods designed for the ENDURA™ TWC1
charger. Disconnect charger from power supply before installing, adjusting, or removing the charging pod.
Make sure contacts in charging pod and battery are clean. Do not allow
wire or metal objects to touch contacts in charging pod or any internal
part of the charger.
Do not remove the charger’s housing or make any modification to the charger.
Use only the power supply provided with the ENDURA™ TWC1 charger. If
a replacement power supply is required, order part number TWC1-C1. Use
of other power supplies may damage the charger or batteries you may be
attempting to charge.
ENDURA™ TWC1 Features
Power Supply
Endura™ TWC1 Single Unit
Rapid Charger
Removable Charging Pod
Charge Status LED
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
Note: Quick reference informa-
tion for charge status is
located on bottom of charger.
1
2
3
4
Loading...