Endura EC-4173 User Manual

Single Unit Rapid Charger

FOR RECHARGEABLE TWO-WAY RADIO BATTERIES

User Manual

Model: EC-4173

1

Overview

The EC-4173 will charge LiPo, Li-Ion, NiMH, and NiCd batteries. This model is
compatible with the radios listed below.

Charger Model Compatible Radios

EC-4173

If you have questions concerning radio or battery compatibility, contact a Power
Products dealer, visit www.powerproducts.com, or call customer service at 800-529-1618.

Motorola CP150, CP200, CP200d, CP200-XLS, CP250, EP450, PR400

Important

1. Always charge new batteries completely before initial use. Recycle batteries when they
can no longer be used. Do not discard unwanted batteries in the trash or incinerate.
Batteries exposed to fire or excessive heat may explode.

2. For best battery performance, charge NiCd and NiMH batteries when they are fully
discharged.

3. Use charger in areas protected from the weather. Do not expose the charger to rain, any
liquids, or excessive moisture.

4. Make sure contacts in charging pod and on the battery are clean. Do not allow wire
or metal objects to touch contacts in charging pod or any internal part of the charger.

5. Do not remove the charger’s housing or make any modification to the charger.

6. Use only the power supply provided with EC-4173. If a replacement is required, order

TWC1-PS.

Charging A Battery

1. Connect the charger to an AC wall outlet with the power supply provided.

2. Place the battery to be charged in the charger. The battery may also be charged

while attached to the radio.

3. When a battery is placed in the charger and while charging, the status LED will
illuminate RED with no flashing to indicate normal charging. If the status LED is red and
flashes, a fault has been detected.