Page 1
INSTALLATION INSTRUCTIONS FOR MODEL NO: YG- 065 BL or YG-065 WH
RECOMMENDED LOCATION: THIS UNIT IS SUITABLE FOR USE OUTDOORS ON WALLS.
Warnings:
The unit must be earthed.
We recommend the use of a qualified electrician for all electrical installations.
Installation must comply with current IEE Wiring Regulations & UK Building Regulations (Part P).
Run supply wire from a 5 amp electrical supply (protected by an RCD – not supplied) using double insulated 3- core
cable of type H05RN- F 1.0mm
GENERAL NOTES:
INSTALLATION:
(1) Switch off mains electrical supply before installation
(2) Run cable (not supplied) from mains electrical supply to selected site, ensuring it is adequately protected
through the full length of the cable run.
Except where installed in a conduit or duct which provides equivalent protection against mechanica
cable buried in the ground shall incorporate an earthed armour or metal sheath or both, suitable for use as a
protective conductor, or be of insulated concentric construction. Buried cables shall be marked by cable covers
or a suitable marking tape. Buried conduits and ducts shall be suitably identified. Buried cables, conduits and
ducts shall be at a sufficient depth to avoid being damaged by any reasonably foreseeable disturbance of the
ground.
(3) Strip outer sheath from the end of supply cable
brown, blue and green/yellow wires and bare the ends for a length of approximately 5mm.
(4) Remove front screw and remove front frame from back plate, lifting upwards and outwards.
(5) Using the back plate as a template, mark position of fixing holes.
(6) Drill holes and fit suitable wall fixing plugs.
(7) Pass the supply cable through the rubber grommet in the back plate.
(8) Remove plastic cover under lamp holder by unscrewing the self tapping screw. Re
(9) Connect the mains supply cable to the connector block as follows:
Incoming Live (Brown wire) to terminal block connector marked “L”.
Incoming Neutral (Blue wire) to terminal block connector marked “N”.
Incoming Earth (Green/yellow wire) to connector marked
(10) Re-fit plastic cover under lamp holder, using the self tapping screw.
(11) Secure the back plate to the wall with suitable screws, ensuring that the arrow on the back plate is pointing up,
and no wires are trapped or damaged.
(12) Fit lamp bulb(s) of type and wattage recommended
indicated.
(13) Re- fit front frame to back plate and secure with screw.
(14) Switch on luminaire and ensure it operates correctly.
(15) Clean only with damp cloth or soapy water. Do not use abrasive cleaners.
If the diffuser is cracked or broken then it must be replaced, if this cannot be done the fitting must be
disconnected. The symbol illustrated below indicates this requirement.
Produced in China for
Endon Lighting
LS9 0SE
2
(not supplied).
l damage, a
from unit for a length of approximately 20mm and separate
tain this screw.
on the lamp holder. Do not exceed maximum wattage
10/04/2015 Ref: Y07 Jv3
Loading...