The Light pack contains:
The following tools may be required:
Moreto-1WBCH
Safety Warnings
INSTRUCTION M ANUAL
This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE
wiring Regulations and should be installed to Part P, UK Building Regulations and is for Domestic
use only. It is not suitable for bathroom use.
The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may
cause overheating and damage the fitting.
This product contains delicate parts – be careful during handling and maintenance to avoid
breakage.
If any modification is made it will invalidate the warranty and may render the product unsafe.
The bulbs become hot during use so please switch off and allow 10 minutes to cool before replacing
bulbs or cleaning the fitting.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Before you start
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used. If
a CFL type bulb is fitted then these cannot (generally) be controlled by a dimmer.
Light fitting and mounting bracket.
Terminal connection block(s).
Shade ring.
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
1
Assembly/ User Instructions
N22 15
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Diagram A
Diagram B
1. Decide on the position of your light fitting.
Ensure there is a solid mounting surface,
preferably a brick or block wall and ensure
that there are no cables or pipes beneath the
surface. If the wall is timber frame and
plasterboard then please use appropriate
fixings. Wall plugs are shown here –
Diagram A. Ensure the fixings used can
support the weight of the wall light.
2. Remove the fixing bracket, by undoing the
side screws (1), retain these for re-us
3. Use the fixing bracket as a template to mark
the screw holes. Make sure the bracket is
horizontal. Fix the bracket to the wall – the
use of plugs (2) and screws (3) are shown
here.
4. Diagram B. Support your fitting and connect
the house wiring to the terminal block
(4).NOTE: This is a Class I fitting and
must be earthed. See wiring details.
5. Re-position the fitting over the wall bracket
and secure with the side screws, removed in
2 above. Make sure
cables and connections are inside the back
plate taking care not to trap or strain the
internal cables.
that all the internal
e.
Endon
LS9 0SE
6. Place the shade (5) over the lamp holder
and secure using the shade ring (6).
7. Fit the bulb (7) into the lamp holder.
NOTE; Never fit bulbs of a higher wattage
than those specified on the label (as
these may cause overheating and
damage the fitting).
8. Turn on the power and test.
Details of terminal wiring.
20/03/2015
2
Loading...