Endeavour Tools ETUC24V Instruction Manual

INSTRUCTION MANUAL

2

3

4

5

1

24V BATTERYLESS JUMP STARTER
ETUC24V

1. Clamps

2. ON / OFF switch 4. Voltage Indicator

3. Condition Indicator 5. GLOW Switch

Technical Specifications:
Input: DC12-24V 20A
Working temperature: -40℃to 65℃(-40℉! to 150℉)
Starting current: 24V 1500 Amp

IMPORTANT SAFETY WARNINGS

1. Read the vehicle owner's manual. The vehicle manufacturer may have specific
precautions / instructions about jump starting your vehicle. You must adhere to
these.

2. Please read the instruction manual for this jump starter carefully before
use. Please ensure you retain this manual for future reference.

3. Please wear safety glasses and gloves while jump starting your vehicle. Ensure
your vehicle is in PARK and that the hand brake is applied

4. Turn off ALL electronics in the vehicle (air conditioner, radio, lights etc) to ensure
the best performance of this jump starter. Ensure the key is in the off position in the
ignition when setting up the jump starter

5. Do not attempt to jump start the vehicle for more than 3 seconds. Allow one
minute between jump start attempts to avoid over heating.

6. In the event that the battery voltage is less than xxV you will need to use the
Bypass (Overide) Mode. [how do you do this]

[WARNING SIGN] Operate with caution as the Reverse Polarity Protection is
DISABLED in Bypass Mode.

[WARNING SIGN] Use this jump starter only with 24V vehicles. This must NOT be
used with 12V vehicles, such as passenger cars / SUVs

Operating Instructions

1. Standard mode

In many situations, provided the vehicle battery has at least xxV residual charge, the vehicle

battery will have sufficient energy to recharge this jump starter. Simply follow these three

simple steps to get your truck started!

1.∑ Connect the jumper clamps to the battery terminals. The voltage

indicators will show the vehicle battery’s voltage.

2.Press the ON / OFF button. The jump starter will attempt to recharge itself

from the residual energy in the battery. The voltage indicators will show the

starter’s voltage during charging.

3. Once the voltage indicator turns green, you can attempt to jump start the

engine. Do not attempt to jump start the engine for more than 3 seconds.

Allow time between jump starts to avoid overheating the jump starter.∑

∑

∑