ENDEAVOUR ET3560 Owner's Manual

1. Keep bod

y face clean, preve

nt liquid material from getting into slider

to destroy electronics.

2. Face should be cleaned with a clean, dry, lint-free cloth. Lubricate
body with a few drops of clock oil. Acetone & alcohol must not be used.

3. Keep battery compartment clean and free of corrosion.

PROBLEM: SOLUTION:

Every second 5 digits Battery voltage is under 1.45V. Remove
jump simultaneously cover and replace battery.

Display cannot count Faulty circuit. Remove battery, after 30

sec. put battery back into compartment.

Display shows 000.00 Function buttons and sliders signal end
or IN 00.000 may have shorted out. Remove the

cover, put the button springs in place
with rubber covers. Contact must be
unobstructed.

Function buttons not active Springs or rubber covers may be out of

shape due to excessive pressing. See
solution above for tips.

Reading error for full Sensor may have dirt or deposits in it
length is ≥ 0.1mm Remove cover and slider assembly.

Blow off sensor face with clean
pressurized air (≥5kg/cm squared),
clean with a dry, lint-free cloth.

No display on LCD screen 1.) Poor battery contact. Check battery

compartment, clean if necessary.

2.) Battery voltage is under 1.3V.
Replace with correct battery.

Digital Caliper

ET 35 60

OWNER'S MANUAL

CARE & MAINTENANCE

TROUBLESHOOTING

In accordance with the

European Directive

ROHS 2002/95/CE

D4 06 07 60503 001

FOR YOUR SAFETY, and
CARE OF THIS TOOL

Please read these instructions
carefully and retain them for future use.

03.04.0487ECC

Your digital caliper was constructed with quality materials and workmanship and will
give you many years of trouble free use when cared for as described in the "Care &
Maintenance" section.

Repeatability:

0.01 mm or 0.0005"

Maximum measuring speed:

1.5m/sec or 60"/sec.

Measuring system:

Non-contaction linear CAP measuring system

Display:

LCD display, minus sign "-", character in 6.35mm/0.25" height

for 5 digits, small digit "5" and "IN" sign for inch measuring unit.

Battery:

SR44/LR44.

Low battery warning by flashing display.

Operating temperature:

0 ℃ ~ +40

℃

Storage temperature:

-20 ℃ ~ +70

℃

Influence of humidity:

Not important within 0 to 80% of relative humidity.

Measurement of external dimensions Measurement of internal dimensions

Measurement of depth Measurement of steps

* ð——…⁄ …5ßð˙ fCfi …˙ g` ⁄ …fi …5ßCfi …ß=fl8CI ˙ ƒƒfðe˙ ßðfl5Cfl—C› …⁄ flCg…ßßð5–J

Measuring Range: Resolution:

0 - 150mm / 0 - 6" 0.01mm / 0.0005"
0 - 200mm / 0 - 8" 0.01mm / 0.0005"

0 - 300mm / 0 - 12" 0.01mm / 0.0005"

Measuring Range: Accuracy:

0 - 100mm / 0 - 4" 0.02mm / 0.001"

200- 300mm / 8 - 12" 0.03mm / 0.0015"

SPECIFICATIONS AND FUNCTIONS

ZERO setting (zero

setting at an

y

position within the
measuring range)

Metric/Inch change over
(true conversion)

ON/OFF
switch

Battery
compartment
cover

CALIPER FEATURES

CALIPER APPLICATIONS