Enda MU-PT100-U010 TECHNICAL DATA

MU-PT100-U010 Analog PT100 Temperature-Transmitter

english

TECHNICAL DATA
Input:
Sensor type:
Measuring range:
Output:
Supply voltage:
Transfer characteristic:
Direct current:
Wire resistance:
Supply voltage min.:
Linearity error:
Accuracy:
Operating temperature range:
Output signal on sensor failure:
Mounting:
Connection terminals:
Dimensions:
Material:
Housing:
Weight:

2-/3-wire

PT100

3

2

1

PT100, 2 or 3-wire connection
PT100 (DIN EN 60751)

the label:

for example. 0..200°C or -50...+100°C

0...10V
12 ... 35VDC, reverse polarity protected
temperature linear
max. 25mA + Load current
min. 1k

Ω
min. 8V
max. 0,05%
max. 0,1%

0... 50°C
0V or > 10,5V
35 mm-rail mounting
Screw terminals with wire protection, 0,2..2,5 mm²
75 x 15 x 53 mm (h x w x d)
Polycarbonate
EMG15
ca. 40g

The output current follows linear at the input
Temperature signal. The signal output measured
between the terminals 4 and 5. Between the sensor and the supply
and output current don`t be galvanic isolated connection.

5

6

4

Input connection diagram

PT100

up to date: 06052019, modification reserved and can be change any time previous notice !

SURAN Industrieelektronik

Dettinger Str. 9 / D-72160 Horb a.N

3
2

1

Tel.: [phone] / 625 617
Fax: [phone]

In the two-wire circuit, the resistance of the
cable in the measuring result. Therefore, this circuit can be
selected only for short lines or low accuracy requirements.
Between the terminals 1 and 2 at the transmitter
a bridge must be clamped.

E-mail : [e-mail]
Internet : www.suran-elektronik.de