(USB DVB-S Video Capture Box / Personal Video Recorder)
ENUTV-DVB-S Series
User’s Guide
Version 1.0
ENUTV-DVB-S User’s Guide -
User’s Notice
This manual is provided “as is” without warranty of any kind, either express or implied,
including but not limited to the implied warranties or conditions of merchantability or fitness
for a particular purpose. In no event shall we, its directors, officers, employees or agents
be liable for any indirect, special, incidental, or consequential damages (including
damages for loss of profits, loss of business, loss of use or data, interruption of business),
even if we have been advised of the possibility of such damages arising from any defect or
error in this manual or product.
Specifications and information contained in this manual are furnished for information
use only, and are subject to change at any time without notice, and should not be
construed as a commitment by us. We assume no responsibility or liability for any errors or
inaccuracies that may appear in this manual, including the products and software
described in it.
No part of this manual, including the products and software described in it, may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language in any form or by any means, except documentation kept by the purchaser for
backup purposes, without the express written permission of us.
Product warranty or service will not be extended if: (1) the product is repaired,
modified or altered, unless such repair, modification of alteration is authorized in writing by
us; or (2) the serial number of the product is defaced or missing.
Products and corporate names appearing in this manual may or may not be
registered trademarks or copyrights of their respective companies, and are used only for
identification or explanation and to the owners’ benefit, without intent to infringe.
Windows, MS-DOS, and DirectX are registered trademarks of Microsoft Corporation.
Adobe and Acrobat are registered trademarks of Adobe Systems Incorporated.
The product name and revision number are both printed on the product itself. Manual
revisions are released for each product design represented by the digit before and after
the period of the manual revision number. Manual updates are represented by the third
digit in the manual revision number.
Chapter 7: Technical Support .......................................................................................................23
3
ENUTV-DVB-S User’s Guide -
Chapter 1: Introduction
1.1 - Package Contents
The following items are included in the ENUTV-DVB-S package.
CD Setup Disc (includes Software Driver and Utility Software)
ENUTV-DVB-S device
Remote Controller
Power adapter
User’s Guide or Quick Installation Guide
1.2 - System Requirements
IBM PC or compatible
USB2.0 compliant interface
Intel Pentium IV 2.0GHz CPU or higher processor (Recommended)
Minimum 256 MB memory
Minimum 1GB hard disk space available
VGA card supports DirectX 9.0c or above
SoundBlaster compatible sound card
One free USB host
Microsoft Windows XP Home or Professional with Service Pack 2
CD-ROM drive for driver and software installation
4
ENUTV-DVB-S User’s Guide -
Chapter 2: Getting Started
2.1 - ENUTV-DVB-S Hardware Installation
Step1: Connect the USB port of PC and DVB-S device with USB cable
Step2: Connect satellite signal to DVB-S
Step3: Connect power socket and power the device on
5
ENUTV-DVB-S User’s Guide -
on
Found New
2.2 - Device Driver Installation
Before You Begin
Make sure that the product is actually installed. (For more information, please refer to
Hardware Installation in the previous section.)
Turn on or restart your computer.
Place the software CD-ROM that comes with the ENUTV-DVB-S in the CD-ROM drive.
Then follow the on-screen installation guide below.
Device driver installation for Windows® XP Home/Professional Edition
1. When the computer has been powered
for the very first time during the setup, a
message “Found New Hardware Wizard”
dialogue box will appear on the screen.
Click “Cancel” button to close “
Hardware Wizard” window.
2. Insert the ENUTV-DVB-S setup CD-ROM
into the CD-ROM or DVD-ROM drive, the
“Driver & Utilities” setup screen will
appear. Click “Install Driver” button.
6
ENUTV-DVB-S User’s Guide -
3. Make sure the “Complete” radio button is
selected then click “Next”
4. Click “Install” to begin install driver.
2.3 - Install the DirectX®
Microsoft DirectX® allows 3D hardware acceleration support in Windows® 98, 2000,
Windows® XP/64 bits and Windows Vista™ 32-bit/64-bit. For software MPEG support in
Windows 98, you must first install Microsoft DirectX®, and then a MPEG compliant video
player. Follow the installation steps below to install MS DirectX®.
1. Insert the installation CD-ROM into the
CD-ROM drive. The setup screen will
automatically appear.
2. Click the “DirectX” button.
7
ENUTV-DVB-S User’s Guide -
3. Click “Accept the agreement” radio button
then click “Next”
4. Click “Next” to confirm the installation of
DirectX
5. Click “Finish”
NOTE:
The computer will automatically restart.
Please close all programs if any and save
files if needed before hitting the “Finish”
button.
2.4 - Install the ENUTV-DVB-S Application.
1. Install TV application on Windows XP Home/Professional Edition
1. Insert the installation CD-ROM into the
CD-ROM drive. The setup screen should
automatically appear.
2. Click the “Setup Utility”
8
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.