ENVCWI-PTG1
Wireless Network (IP) Camera with PAN & TILT
The ENCORE ENVCWI-PTG1 Wireless Network (IP) Camera with PAN & TILT is a
cost-performance effective but most powerful IP Camera product which allows you to
implement multiple applications of home surveillance, security or remote caring on LAN or
over the Internet.
With user friendly in mind, the IP finder utility software provided could help you find the IP
camera in your LAN and configure the IP address easily. With Ultra View software provided,
you could configure and manage multiple IP Cameras in one application software. And, you
could also manage the IP Camera through web browser software and look at the remote
video image remotely over the Internet. With its high power performance design, it provides
you the crystal clear M-JPEG video and image at maximum 30 frames per second in VGA,
QVGA and QQVGA resolutions. With its Pan-Tilt capability, you could view most view angles
of installed circumstance by remote control manually or 8 preset view angles.
The ENVCWI-PTG1 is the right tool you would ever need for applications of home
surveillance, security or remote caring on LAN or over the Internet, with the ability to view
most view angles of installed circumstance remotely.
Features and Benefits
M-JPEG codec Supported: The camera provides you with excellent images by the
M-JPEG codec technology, allowing you to adjust image size and quality, and bit rate
according to the networking environment.
2-way Audio Capability: The built-in microphone of the camera provides on-the-spot
audio via the Internet, allowing you to monitor the on-site voice. In addition, you can
connect an external speaker to the camera to speak through the camera.
Optimal Viewing: With the pan/tilt functions, you can easily monitor everywhere via
the camera by moving the camera lens to the left/right (165/165 degrees) or up/down
(90/15 degrees). In addition, you can assign up to eight positions for the camera,
enabling you to move the camera lens to the desired position quickly.
I/O Connectors Provided: The camera provides the I/O connectors on the rear panel
(IN/OUT), which provide the physical interface to send and receive digital signals to a
variety of external alarm devices. You can connect a special featured device, and then
configure the settings and control the device from the GPIO Trigger window of Web
Configuration.
Remote Control Supported: By using a standard Web browser or the bundled
UltraView software application, the administrator can easily change the configuration of
the camera via Intranet or Internet. In addition, the camera can be upgraded remotely
when a new firmware is available. The users are also allowed to monitor the image and
take snapshots via the network.
Multiple Platforms Supported: The camera supports multiple network protocols,
including TCP/IP, SMTP e-mail, HTTP, and other Internet related protocols. Therefore,
you can use the camera in a mixed operating system environment, such as Windows
2000, Windows XP, Windows Vista, and so on.
Multiple Applications Supported: Through the remote access technology, you can
use the cameras to monitor various objects and places for your own purposes. For
example, babies at home, patients in the hospital, offices and banks, and more. The
camera can capture both still images and video clips, so that you can keep the archives
and restore them at any time.
Surveillance Supported: The camera supports “nightshot mode” to deliver clearer
images in the low lux environment. Enable motion detection and setup automated email
alerts and upload FTP for security.
Specification
s and
Image Sensor
Sensor 1/4" color CMOS Sensor
Resolution 640x480
Minimum Illumination 0.5 LUX
Lens
Lens Type Board Lens
Aperture (F/No.) 1.8
Focus Length 4.0mm
View Angle(Diagonal) 64 degree
Image Processing
Compression M-JPEG
Auto Exposure Control Yes
Auto White Balance Yes
Auto Gain control Yes
Image Resolution
Frame Rates
System Hardware
Processor ARM9 based processor
RAM 32MB SDRAM
ROM 4MB NOR Flash
Power DC 12V
Power Consumption 9 watts maximum
Audio
Audio In
Audio Out External output to active speaker ; Mono
Audio Codec PCM
Pan-Tilt
Pan range +165 ~ -165 degrees
VGA (640 x 480), QVGA (320 x 240), QQVGA (160 x 120): 30 fps
max.
Internal Omni-directional Microphone,
Sensitivity: -48dB +/- 3dB,
Freq Response: 50~16000Hz
Tilt Range +90 ~ -15 degrees
Preset Positions 8 positions
Communication
Ethernet IEEE 802.3u 10/100Mbps Fast Ethernet with Auto-MDI-X
Wireless IEEE 802.11g/b compliant wireless LAN interface
HTTP,
Protocols supported
TCP/IP, UDP, ICMP, DHCP, NTP, DNS, DDNS, SMTP, FTP,
PPPoE, UPnP
Interfaces
GPIO 1 in / 1 out
LAN One RJ-45 port
WLAN One external detachable dipole antenna
One Reset button:
Reset
push and hold for 5 seconds for factory default settings
LED indicators Power LED (amber); Link/Act. LED (green)
Software Features
Brightness
Image setting
Saturation
Contrast
Upside down, Mirror Yes
Digital Zoom 3x
Frame Rate Setting Yes (1~25fps, auto)
Compression Ratio
Setting
5 levels setting:
Lowest, Low, Normal, High, Highest
Static IP Address
IP Setting
DHCP
PPPoE
Support SMTP mail
Email
Two destination email accounts
Manual Time Setting
Time Management
Time Server and NTP Support
Events Triggered by Motion Detection/according to Schedule/GPIO
Event Management
Image Upload/Send over email, FTP
Rigger GPIO out
Flexible Schedule profile for scheduling Motion Detect / FTP upload /
Schedule Profile
Send email / GPIO Trigger
Motion Detection 2 scalable windows
Web Based Administration
System Management
Application Software
Device Configuration Backup/Restore to/from Configuration file
Password protected and 3 levels of Authorization:
User Administration
General User can view Video and listen to Audio only.
General User has all authority in live view page.
Administrator has View video and All configuration setting.
Wireless Security WEP 64/128 bit, WPA-PSK, WPA2-PSK
System log 100 items (max.) stored in SDRAM
Reset Function
LED control Normal / Off
Smart Setup Wizard Step by step quick installation setup
Browsers Support
API For developing application software
OS Supported Windows® 2000/XP/Vista™
Application Software
IP Finder Auto search IP address of camera on your LAN
Operating Environment
System reboot button.
Reset all settings to factory default values button.
Internet Explorer 6.0 above
Mozilla Firefox 2.0 or above
Apple Safari 2 or above
View channels:16 CHs
Record
Playback
Motion detect
Backup/Restore to/from Configuration file
Temperature Operation: 05°C ~ 45°C
Storage: -15°C ~ 60°C
Humidity Operation: 20% ~ 85% non-condensing
Storage: 0% ~ 90% non-condensing
Safety
Regulations FCC/CE Class B
System Requirements
Networking
LAN: 10Base-T Ethernet or 100Base-TX Fast Ethernet.
WLAN: IEEE 802.11g/b compliant wireless LAN interface
Accessing the Camera using Web Browser:
Platform:
Microsoft® Windows® 2000/XP/Vista
CPU: Intel Pentium III 350MHz or above
RAM: 128MB
Resolution: 800x600 or above
User Interface:
Microsoft® Internet Explorer 6.0 or above
Apple Safari 2 or above
Mozilla Firefox 2.00 or above
Accessing the Camera using UltraView
Platform: Microsoft® Windows® 2000/XP/Vista.
Hardware Requirement:
1 camera connected: Intel Pentium III 800MHz; 512MB RAM
2 ~ 4 cameras connected: Intel Pentium 4 1.3GHz; 512MB RAM
5 ~ 8 cameras connected: Intel Pentium 4 2.4GHz; 1GB RAM
9 ~ 16 cameras connected: Intel Pentium 4 3.4GHz; 2GB RAM
Resolution: 1024x768 or above
NOTE: If you connect multiple cameras to monitor various places simultaneously, you
are recommended to use a computer with higher performance.
Package Contents
One Wireless Network (IP) Camera with PAN & TILT.
One AC Power Adapter.
One External Antenna
One Camera Stand.
One Ethernet Cable (RJ-45 type).
One Installation CD-ROM.
One Quick Installation Guide.
※ The specifications and picture are subject to change without prior notice! Please refer to the directions in product package
Loading...