
IEEE802.11g 108Mbps Wireless Access Point
Product Description
For users seeking a simple solution to improve the reach of their wireless signal within their
home or office, the ENRXWI-SG is the answer. This Wireless Access Point takes an
existing 802.11g wireless signal and "repeats" it to enable wireless connectivity in the
basement, patio, garage or any "dead spot" areas where your original wireless signal could
not reach.
The ENRXWI-SG Wireless Access Point is capable of repeating the signal of virtually any
802.11g wireless router or access point out on the market today. At the same time, the
ENRXWI-SG can still communicate with other 802.11b/g wireless client devices.
Setup takes only a couple of minutes and keeps your network free from additional cables.
After quick configuration, place the Wireless Access Point in close proximity of your
wireless router or access point and begin offering a reliable connection to the rest of your
home.
The ENRXWI-SG Wireless Access Point also features WPA-PSK, WPA2-PSK and WEP
for secure wireless communication over the network. With this level of security, your data is
kept safe from the prying eyes of unauthorized users.
The ENRXWI-SG Wireless Access Point is the most cost efficient solution for increasing
the range of your wireless network.
Features:
Fully IEEE 802.11g and 802.11b standards compliant.
Highly efficient design mechanism to provide unbeatable performance achieving data rate up to 108
Mbps for 802.11g and 11 Mbps for 802.11b with wide range coverage.
Strong network security with 802.1x, and WEP encryption.
Auto-switch between the two standards IEEE 802.11 b and g that the corresponding networking device
is using.
Support WEP encryption for network security.
Compliant with IEEE 802.3u and auto-negotiation.
Support Full-duplex 802.3x and Half-duplex back-pressure flow control.
Auto MDI/MDIX Fast Ethernet Port
LED indicator indicates connection status.

IEEE802.11g 108Mbps Wireless Access Point
Specification Tables:
Standards
IEEE 802.11b Wireless LAN
IEEE 802.11g Wireless LAN
IEEE 802.3/IEEE 802.3u Fast Ethernet
ANSI/IEEE 802.3 Auto negotiation
Radio Technology
Direct Sequence Spread Spectrum (DSSS)
Orthogonal Frequency Division Multiplexing (OFDM)
Transmission Rate
802.11b: 1, 2, 5.5, 11Mbps (auto sense)
802.11g: 6, 9 12, 18 24, 36, 48, 54, 108Mbps (auto sense)
Receiver Sensitivity
54Mbps: Typical -70 @ 10% PER (Packet Error Rate)
11Mbps: Typical -85 @ 8% PER (Packet Error Rate)
Wireless LAN Frequency Range
2412 ~ 2484 MHz ISM band (channels 1 ~ 14)
Modulation Schemes
DBPSK/DQPSK/CCK/OFDM
Media Access Protocol
CSMA/CA with ACK
Transmit Power
802.11g: 15±2dBm
802.11b: 15±2dBm
Antenna Type
Dual diversity antennas with one internal printed antenna and one external 2 dB Gain dipole
antenna
Protocol
TCP/IP
Interface
LAN: 1 x 10/100Mbps Auto-MDIX Ethernet ports

Supported Network Protocols
802.3u: 10/100Mbps Fast Ethernet, IP v4, UDP, ICMP, TCP
DHCP
Network Management
Web base configuration utility via Ethernet
Channel
USA: Channel 1 ~ 11
Europe: Channel 1 ~ 13
Japan: Channel 1 ~ 14
Security
WEP 64/128
Wi-Fi Protected Access (WPA)
WPA-PSK
SSID Broadcast Disable function
MAC Filter
Range Coverage
Indoor: 30 ~ 50 meters (depends on environment)
Outdoor: 50 ~ 200 meters (depends on environment without XR)
400 ~ 450 meters (depends on environment with XR)
Diagnostic LEDs
Power
LAN: Link, ACT
WLAN: ACT
Power Adapter
5V / 2A
Operation Temperature
0 ~ 40°C
Storage Temperature
-10 ~ 70°C
Humidity
10% ~ 95% RH, no condensation
Certifications
FCC Part 15.247 for US
ETS 300 328 for Europe
Dimensions (W x H x D)
146 x 113 x 41 mm (without antenna)

Encore Electronics 2006
WWW.ENCORE-USA.COM
ENRXWI-SG
Figure 1: Usage Diagram