Encore ENRXWI-G User Manual

IEEE802.11g 54Mbps Wireless Access Point ENRXWI-G

Product Description

For users seeking a simple solution to improve the reach of their wireless signal within their home or
office, the ENRXWI-G is the answer. This Wireless Access Point takes an existing 802.11g wireless
signal and “repeats” it to enable wireless connectivity in the basement, patio, garage or any ”dead
spot” areas where your original wireless signal could not reach.

The ENRXWI-G Wireless Access Point is capable of repeating the signal of virtually any 802.11g
wireless router or access point out on the market today. At the same time, the ENRXWI-G can still
communicate with other 802.11b/g wireless client devices.

Setup takes only a couple of minutes and keeps your network free from additional cables. After quick
configuration, place the Wireless Access Point in close proximity of your wireless router or access
point and begin offering a reliable connection to the rest of your home.

The ENRXWI-G Wireless Access Point also features WPA-PSK, WPA2-PSK and WEP for secure
wireless communication over the network. With this level of security, your data is kept safe from the
prying eyes of unauthorized users.

The ENRXWI-G Wireless Access Point is the most cost efficient solution for increasing the range of
your wireless network.

Features:

Provide Ethernet to Wireless LAN bridge fully compatible on Ethernet side and fully IEEE 802.3
compatible on the Ethernet side and fully interoperable with IEEE 802.11g compliant equipment

Provide 10/100 BASE-TX Fast Ethernet interface
IEEE 802.11g Infrastructure operating mode
Dynamic date rate scaling at 54, 48, 36, 24, 18, 12, 9 and 6Mbps for 802.11g
Dynamic date rate scaling at 11, 5.5, 2 and 1Mbps for 802.11b
Allow auto fallback data rate for optimized reliability, throughput and transmission range
Supports wireless data encryption with 64/128-bit WEP standard for security
Supports WDS bridging function
Supports AP Client mode
Supports wireless security standards WPA, WPA-PSK, WPA2, WPA2-PSK
Web-based configuration management

IEEE802.11g 54Mbps Wireless Access Point ENRXWI-G

Specification Tables:

Standards:

IEEE 802.11b/g (Wireless LAN)
IEEE 802.3u (Fast Ethernet)

Radio Technology

802.11b: Direct Sequence Spread Spectrum (DSSS)

802.11g: Orthogonal Frequency Division Multiplexing (OFDM)

Transmission Rate

1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54Mbps (auto sense)

Receiver Sensitivity

54Mbps: Typical -68dBm @ 10% PER (Packet Error Rate)

11Mbps: Typical -78dBm @ 8% PER (Packet Error Rate)

Wireless LAN Frequency Range

2412 ~ 2484 MHz ISM band (channels 1 ~ 14)

Modulation Schemes

DBPSK/DQPSK/CCK/OFDM

Media Access Protocol

CSMA/CA with ACK

Transmit Power

802.11g: Typical 15dBm

　 802.11b: Typical 18dBm

Antenna Type

One external 2dB dipole antenna

Interface

10/100BASE-TX RJ-45 Ethernet

Network Management

Web base configuration via Web Browser

Channel

USA: 1 ~ 11
Europe: 1 ~ 13
Japan: 1 ~ 14