Encore ENDSL-AR4 Specifications

Page 1
ADSL Modem + 4 Port Router
ENDSL-AR4
The ENDSL-AR4 is an ADSL modem with 4 Ethernet port and one USB
2.0 port. It features “always-on” capabilities and enables high-speed broadband connection from a DSL line to any devices connected to the 4 Ethernet ports. The ENDSL-AR4 ensures not only maximum performance, but also significantly simpler handling process. Access the Internet, E-mail, and FTP simultaneously from the LAN with a single DSL line. It can also provide one-to-one Ethernet connection to any PC either by USB (Version 2.0)
This ADSL Ethernet Router is fully compliant with ANSI T1.413 Issue 2, ITU-T G.dmt, ITU-T G.lite standards. Using existing twisted-pair telephone lines, ADSL technology provides data rate more than 100 times faster than a traditional analog modem without interruption of telephone service.
In addition, the ENDSL-AR4 provides a friendly configuration interface that aims for easy installation for SOHO and residential users. Its internal country settings will allow the router to function with ease in other countries. This product is made to comply with the ISO9001 industry standard; it also complies with FCC part15 and CE regulations.
Encore Electronics 2005 ENDSL-AR4
Figure 1 Rear View
1
Page 2
Figure 2 Usage Diagram
Encore Electronics 2005 ENDSL-AR4
Figure 3 Web Interface
2
Page 3
Product Specifications and Details
Supported ADSL Standards
ANSI T1.413 issue 2
ITU-T G.992.1 (G.dmt)
ITU-T G.992.2 (G.lite)
G.994.1 (G.hs, Multimode)
ITU-T G.992.3 (ADSL2 G.dmt.bis)
ITU-T G.992.4 (ADSL2 G.lite.bis)
ITU-T G.992.5 (ADSL2+,Annex A, B, I, J, L
& M)
Reach Extended ADSL (RE ADSL)
ATM Support
Support up to 8 PVCs ATM Forum UNI
3.1/4.0 PVC Traffic Shaping UBR, CBR, VBR-nrt Multi Protocol over AAL5 (RFC1483 /
2684)
Classical IP over ATM (RFC 1577)
OAM F4 and F5 segment end-to-end
loopback, AIS, and RDI
OAM cells
VC and LLC Multiplexing
VPI is 0-255 and VCI is 32-65535
ATM SAR (Segmentation and
Reassembly)
PPP over Ethernet (RFC 2516)
PPP over ATM (RFC 2364)
PPP over PAP (Password Authentication
Protocol; RFC1334)
PPP over CHAP (Challenge Authentication Protocol; RFC1994)
Bridging and Routing
Ethernet to ADSL self-learning
Transparent Bridging (IEEE 802.1D)
IP routing-RIPv2 (backward compatible
with RIPv1)
Routing (TCP/IP/UDP/ARP/ICMP)
Static IP routing
ICMP (Internet Control Message Protocol)
IGMP (Internet Group Management
Protocol)
IP Multicast IGMP v1/v2
MIB II Support (RFC1213)
PAT (Port Address Translation)
Security
PAP (Password Authentication Protocol)
CHAP (Challenge Authentication Protocol)
User authentication for PPP
Password Protected System Management
VPN (IPSec, PPTP, L2TP) Pass-Through
HTTP Web-based management
Firmware upgrade via FTP / TFTP (Web-
based)
SNMP Support
WAN and LAN connection statistics
Selection of Bridge or Router Mode
Configuration of VCs (Virtual Circuits)
Configuration file backup and restore
Hardware Interface
One USB port compliant with USB v1.1, full speed (12Mbps)
Four RJ45 ports compatible with IEEE
802.3/802.3u, 10/100Mbps auto selection
One RJ11 port for ADSL connection
One Power switch button for power on/off
One reset button for restoration of factory
default setting
Support Operating Systems
Windows 9X, ME, 2000, XP,Linux and MAC
Power Requirement
Power Adapter: Input 110+
VAC, Output 12VAC, 1000mA
Power Consumption: less than 10 Walt
Environmental
Operating temperature: 0°C ~ 70°C ambient
Humidity: 5 % ~ 95 % (non condensing)
Storage temperature:-40°C ~ 70°C
10 or 230+10
Encore Electronics 2005 ENDSL-AR4
3
Page 4
IP Management
NAT (Network Address Translation)
NAPT (Network Address and Port
Translation)
DHCP Server/Relay/Client (WAN port)
VPN (IPSec, PPTP, L2TP) Pass-Through
DNS Proxy
DDNS
UPnP support
Certification
FCC part 15, CE mark
Encore Electronics 2005 ENDSL-AR4
4
Loading...