Encore 52K700ZP, Mid-Cut, 61K28A, 52K650ZP, 52K850ZP Operator's Manual
...
6 1 K 6 5 0 P
OPERATORS
MANUAL
WARNING:
CAUTION:
NOTES:
GENERAL
This manual contains techincal data on the
following Encore commercial mowers.
an Authorized Encore Dealer . To ensure
optimum performance and safety , always
purchase genuine Encore replacement parts
and accessories
52K650ZP ; 52K700ZP ; 52K850ZP ; 61K650P
61B850P ; 61B950P ; 61K650ZP ; 61K700ZP
61K850ZP ; 61B850ZP ; 72B850P ; 72B950P
72B850ZP ; 72K850ZP -- 52K23A ; 52K25A 52K27L ;
61K27L; 51B27LD ; 61K25A ; 61B31LP 72K27L ;
72B27LD ; 72B31LP
INTRODUCTION
Y our mower was built to the highest standards in
the industry . However, the prolonged life and
maximum efficiency of your mower depends on
you following the operating, maintenance and
adjustment instructions in this manual.
We encourage you to contact your local Encore
dealer for repairs. All Encore dealers are
informed of the latest methods to service this
equipment and provide prompt and efficient
service. They carry a full line of Encore service
parts.
SIGNAL WORDS
This symbol means “Attention! Become
Alert! Your Safety is Involved!” The symbol
is used with the following signal action words
to attract your attention to safety messages.
The message that follows the symbol contains important information about safety.
Signal Word:
A replacement Operator’s Manual is available
from your Encore Dealer or by contacting
Encore Manufacturing Co., Inc., Service
Department at PO Box 888, Beatrice, NE
68310. Please indicate the complete model
and serial number of your Encore product.
The “Right” and “Left”,”Front” and “Rear” of the
machine are referenced from the operator’s
perspective when in the normal operating
position and facing forward travel direction.
GENERAL SAFETY INSTRUCTIONS
READ THIS OPERA T OR’S MANUAL and
instructions furnished with attachments.
Perform only those maintenance procedures
described in this manual. If major repairs are
ever needed or assistance is desired, contact
The signal action word “ WARNING” denotes
that a hazard exists on or near the machine
that can result in injury or death if proper
precautions are not taken.
The signal action word “CAUTION” is a reminder of safety practices on or near the
machine that could result in personal injury if
proper precautions are not taken.
The signal action word “NOTES” denotes
relevant information to assist you in the performance of a task.
1
ENCORE PROWLER MID CUT
WARNING:
DO NOT allow children to operate the machine.
DO NOT allow any adult to operate the
machine without proper instruction.
CAUTION:
Never add fuel to the tank while the engine is
running or hot. ALWAYS WAIT at least five
minutes before refueling and REFUEL WITH THE
ENGINE OFF. KEEP FUEL AWAY FROM
SPARKS OR FLAMES. WIPE AWAY any fuel
spillage BEFORE starting unit. Never fill the fuel
tank indoors. Wipe up any spilled gasoline.
Gasoline is highly flammable - NO SMOKING .
Your mower is only as safe as the operator!
Operator carelessness or error may result in
serious bodily injury. Improper maintenance of the
machine may also result in injury. Please read and
follow these instructions on Safe Operation and be
certain that anyone using this mower fully
understands and follows these instructions.
1. Familiarize yourself with the controls and know
how to stop the rider and mower deck quickly.
2. Inspect your work area carefully. Remove debris
from the area to be cut. Keep all bystanders away
from the mowing area.
8. Drive levers must be in the Neutral position and
the Blade Clutch must be disengaged before
starting engine.
9. Operator must wear proper shoes and clothing,
which may include safety glasses and ear protection.
10. Mow only during daylight hours or under very good
artificial light.
11. The safety shield over the Grass Discharge area
must always be bolted in place and in the DOWN
position unless the Grass Catcher is being used.
12. If a solid object has been hit by the blades stop the
machine and check for damage. Repair or replace
any damaged/broken part prior to restarting the
engine.
13. To avoid burns, DO NOT TOUCH the engine or
muffler immediately after operation.
3. Avoid contact with moving parts. Keep hands and
feet clear of the mower deck.
4. Never direct the discharge of material toward
bystanders nor allow anyone near the machine
while in operation.
5. The machine is not intended for highway or street
use. Never carry passengers!
6. Never tamper with safety devices or guards. If a
guard or safety device is damaged or removed,
replace it before operating the rider.
7. Handle gasoline carefully. Use an approved
gasoline container. Fill the fuel tank, to within 1"
from the neck, with good quality unleaded gasoline.
14. Disengage blades when transporting and when
crossing walks and gravel roads.
15. Do NOT mow close to drop-offs, deep ditches or
other hazards. Do NOT stop or start suddenly
when going uphill or downhill. Mow up and down
the face of steep slopes; NEVER mow across the
face. If a steep hill must be ascended, BACK up
the hill, drive forward when descending.
16. Reduce speed and exercise extreme caution on
slopes and in sharp turns to prevent tipping or loss
of control. Be especially cautious when changing
direction on slopes.
17. The Mid-Cut Prowler is NOT designed for towing.
Only factory approved Grass Collection
Systems are permitted.
2
ASSEMBLY INSTRUCTIONS:
1. Remove tractor from the crate. Lay out all the
hardware and parts from the inner box:
Parts will consist of:
1 - seat
1 - bolt bag
1 – literature packet
2 - handles
5. Place breather cap on oil tank. Note: The oil tank
is pre-filled from the factory with 20w50 oil and
should be visible in the sight glass located on the
back of the tank. The correct level is mid-point in
the sight glass.
Battery:
Units SN 43276 & above have sealed
battery - Require no filling or charging
2. Open bolt bag and lay out
1 - oil breather cap
4 - 5/16-18 X 1 ¼ bolt
4 - 5/16-18 whiz lock nut
4 - 5/16-18 nylock nut
4 - 5/16- std flat washers
3. Take 4 - 5/16 std flat washers and 4 - 5/16
nylock nuts and bolt the seat into place. Slide the
studs of the seat though the seat plate and secure
with one flat washer and nylock nut on each of the
4 studs. (Slide the seat all the way back onto seat
tracks in order to flip seat forward.) At this time
you may also connect the seat switch wires.
4. Using the 4 - 5/16 – 18 X 1 ¼ bolts, bolt the
handles into place. Note: Handle mounts to the
outside of the square control block with whiz locks
located on slotted or handle side.
Important for unit s prior to SN 43276:
Do not overfill battery! Electrolyte will
overflow onto parts of the machine,
resulting in severe corrosion.
THE MACHINE IS SHIPPED WITH A DRY
BA TTER Y!!
1. Remove the battery from the machine. Tilt seat
up to gain access to the battery. Disconnect
battery cables- NEGA TIVE (black) CABLE FIRST.
Remove battery hold down and lift battery out.
2. Place battery on a level surface and remove
vent caps.
3. Fill cells with battery grade sulfuric acid (1.265
specific gravity) to halfway between the top of the
separators and bottom of vent well.
4. Let battery stand for ½ hour after filling.
If battery acid level has fallen, refill to level above
plates.
5. Charge the battery at 4 to 5 amps for 3-5 hours.
6. After charging, install vent caps and wash off
any acid with water and dry battery.
7. Install battery in machine and secure battery
hold-down. DO NOT over tighten.
When reconnecting the battery cables the
POSITIVE (red) CABLE MUST BE ATTACHED
FIRST, then connect the Negative (black) Cable
and black wire to the battery terminal. Slip the
insulator boot over the Positive Terminal.
NOTE: If time does not permit charging the
battery, or if charging equipment is not available,
follow steps 1-4 and install as described in step 7.
Then run to vehicle continuously for 20 to 30
minutes to sufficiently charge the battery.
3
Fuel and Oil Recommendations
CAUTION:
Engines are NOT shipped serviced from
factory. You must service engine before
cranking it!
CAUTION:
On Diesel engine model series 432447, 522447
& 582447 - THESE ENGINES ARE CERTIFIED
TO OPERATE ON DIESEL FUEL ONLY.
NOTE:
Consult Engine Manual for Engine
Manufactures Recommendations on
Operation and Maintenance Information.
CAUTION:
ENGINES ARE SHIPPED WITHOUT OIL.
SERVICE ENGINE AND RECHECK OIL LEVEL
BEFORE ST ARTING.
GAS UNITS FUEL:
Use only clean, fresh, unleaded regular grade
gasoline.
If gasoline is spilled, wipe it up immediately .
DIESEL UNITS FUEL:
Use clean, fresh diesel with a minimum of 40
cetane. Purchase fuel in quantity that can be used
within 30 days to assure fuel freshness.
Note: DO NOT use kerosene or gasoline instead
of diesel fuel. Failure to observe this caution will
damage engine.
CAUTION:
Do not mix oil with gasoline.
OCT ANE RATING:
The octane rating of gasoline is a measure of its
resistance to “knocking”. Using a minimum of 87
octane by the anti-knock index is recommenced.
The anti-knock index is posted on service station
pumps in the U.S.A.
NOTE: If “knocking or pinging” occurs, use a
different brand of gasoline or higher octane rating.
Oxygenates (either ethanol or MTBE) are added
to the gasoline. If you use the oxygenated fuel be
sure it is unleaded and meets the minimum octane
rating requirement.
! WARNING !
Gasoline is extremely flammable and can be
explosive under certain conditions.
ALL UNITS FUEL LEVELS:
Keep tank full. Do NOT over fill. Allow space in
tank for fuel expansion. Check for fuel leaks at fuel
filter, injector pump, fuel pipes and etc.
If the fuel tank does run dry and the engine is
equipped with a fuel filter with priming pump,
stroke the pump to bleed the air from the fuel filter
system.
ENGINE OIL:
Before refueling, turn the engine switch OFF. Do
not smoke! Make sure the area is well ventilated
and free from any source of flame or sparks,
including any appliances with a pilot light. Never
fill tank so that fuel level rises into the filler neck. If
tank is overfilled, heat may cause fuel to expand
and overflow through vents in tank cap. After
refueling make sure tank cap is securely closed.
The following oils are recommended for gasoline
engines.
API Service Classification: SF, SG, SH or SJ
4
Loading...