IPC-600P
Installation guide
Hardware Overview
Network Side
Interface:
Ethernet: RJ45
Coax: BNC
DC Input: DC Jack
Green LED: Ethernet communication status
Orang LED: Coax communication status
Camera Side
Interface:
Ethernet: RJ45
Coax: BNC
DC Input: DC Jack
Green LED: Ethernet communication status
Orang LED: Coax communication status
Configuration Examples
PoE Powered solution:
Install steps:
1. First, insert one end of an Ethernet cable to IP Camera and insert the other end
into Ethernet port of IPC-600R.
2. Connect a coaxial cable between the IPC-600T and the IPC-600R.
3. Insert one end of an Ethernet cable to into Ethernet port of IPC-600T and insert
the other end into your POE Ethernet Switch or POE Injector.
External power supply with non-PoE switch solution:
Install steps:
1. First, insert one end of an Ethernet cable to IP Camera and insert the other end
into Ethernet port of IPC-600R.
2. Connect a coaxial cable between the IPC-600T and the IPC-600R.
3. Insert one end of an Ethernet cable to into Ethernet port of IPC-600T and insert
the other end into your NVR (or computer).
4. Finally, connect the power adapter’s cord into the DC input of the IPC-600T and
plug AC plug to power source (such as a wall socket or power strip).
Multi IPC-600R application solution:
Install steps:
1. First, insert one end of an Ethernet cable to IP Camera and insert the other end
into Ethernet port of IPC-600R.
2. Connect a coaxial cable between a Splitter output and the IPC-600R.
3. Install others IP Camera and IPC-600R such setp1 and step2.
4. Connect a coaxial cable between the Splitter input and the IPC-600T
5. Insert one end of an Ethernet cable to into Ethernet port of IPC-600T and insert
the other end into your NVR (or computer).
6. Finally, connect the power adapter’s cord into the DC input of the IPC-600T and
plug AC plug to power source (such as a wall socket or power strip).
Camera side local power solution:
Install steps:
1. First, insert one end of an Ethernet cable to IP Camera and insert the other end
into Ethernet port of IPC-600R.
2. Connect a coaxial cable between the IPC-600T and the IPC-600R.
3. Insert one end of an Ethernet cable to into Ethernet port of IPC-600T and insert
the other end into your NVR (or computer).
4. Connect the power adapter’s cord into the DC input of the IPC-600T and plug AC
plug to power source (such as a wall socket or power strip).
5. Finally, connect the power adapter’s cord into the DC input of the IPC-600R and
plug AC plug to power source (such as a wall socket or power strip).
Loading...