Enclume FTFK1040 Installation & Assembly

Brackets shown with Rolled End Bar
Wall Brackets for Rolled End Bars
Pot Hooks and Rolled End Bar must be purchased separately.
WB4/RB36, WB4/RB48
If you need assistance, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Enclosed you will find everything needed for the assembly of Enclume’s wall brackets.
The parts and hardware included are:
2 – Wall Brackets 4 – 2” Lag Screws
1- 7/32 hex wrench
6 - PHS Hooks – RB36” 12 – PHS Hooks – RB48” Toggler Kit
Assembly and Installation Instructions:
1) If your rack is plated, it is best to keep the tissue on during installation to avoid fingerprinting.
2) The wall brackets have been shipped assembled. Before installation, check to confirm the screws have
remained tight during shipping. Use your 7/32” Allen wrench to tighten the button head screw.
3) Mount the wall brackets onto the wall using four lag screws. The lags must go into solid wood of wall studs
or into a wooden wall. If it is not convenient to hang your rack directly into wood studs you may use the included DRYWALL anchors enclosed with your rack. See Toggler® brand manufacturer recommendations for weight limits included in the instructions in the Toggler kit.
4) Slip the rolled end bar into the slots on the front of the wall brackets. The assembly is now complete.
5) Hang the pot hooks from the bar.
6) Heavier items must be hung from the center of the bar and be placed on the center of the shelf. Do Not use
the area outside the brackets to hang heavy cookware or to store large and heavy items on the shelf.
WARNING: It is important that your wall brackets is assembled correctly. If the unit is assembled or used incorrectly, it could become unstable and collapse, possibly causing injury.
LIMITED WARRANTY: This product is warranted to be free of material defects, other than that from normal use, for a period of five years from the date of purchase. Customer's exclusive remedy shall be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20 days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS
.
Loading...