Enclume EN1323 Installation & Assembly

PR33-Scrolled Arm Oval Cookware Rack

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,
design, strength and function.

WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK

If you need help, please call 1-877-ENCLUME

24 Colwell Street, Port Hadlock, WA 98339

Phone [phone]  Fax [phone]

Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:

Hardware included:
6 – 3/8” x 1” Button Head Screws
6 –3/8” Nuts
2 – Ceiling Screw Hooks (Large)
2 – 5” Extension Hooks
1 – 7/32” Allen Wrench
12 – Angled Pot Hooks
12 – Straight Pot Hooks
2 – Grid Brackets
Toggle Kit

Components included:

1 – Oval Base
1 – Grid
4 – Arms
1 – Upper
4 – “L” shaped Grid Brackets

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Enclume Design Products

www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Rack Assembly

1) If your rack is stainless steel it is best to keep the tissue on during installation to avoid fingerprinting.

2) Place rack body (also called the oval) on the floor or other “firm” surface.

3) Attach the four arms to the OUTSIDE of the oval using the 3/8” x 1” button head screws. From the outside, thread the button

4) Attach the upper bar to the four arms using the two screws and two nuts. Insert the extension hooks into the holes in the upper

5) Square up the arms and tighten all the screws with the Allen wrench. The assembly is now complete.

6) Carefully place the grid (from one end) between the arms until it fits into the oval and rests on the arm tabs for support. Two

7) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where the

8) Hang your heavier items on the straight portion of the rack between the hanging arms or from the upper bar between the

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20
days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.

head through the arms, the oval and grid bracket (long side down). Secure with 3/8” Hex nut. Make sure the arm orientation is
correct. The 90 degree bend is facing towards the center of the rack and is approximately even with the bottom of the rack body.
Leave the four button head screws slightly loose.

bar.

people make this step easier.

rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to hang your rack
directly into wood joists you may use the included DRYWALL anchors enclosed with your rack. See Toggler® brand
manufacturer recommendations for weight limits included in the instructions in the Toggler kit.

extension hooks.

WARNING

It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.