Wine Storage Rack
WSR1a
WSR1b
WSR1a, WSR1b
If you need assistance, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Enclosed you will find everything needed for the assembly and use of your wine storage rack. Two people make
assembly and installation easier.
Components and Hardware:
2 – Pre-Assembled body pieces
2 – Legs
4 – 3/8” x ½” Button head screws
1 –7/32” Allen wrench
4 – Felt protection pads
Assembly Instructions:
1) Invert the U shaped body pieces on a flat surface about 9” apart.
2) Place the 2 leg pieces across the body pieces. Insert the 4 button head screws through the legs and up into
the body base. Hand tighten.
3) Turn the assembled rack over, square it up and tighten all screws.
WARNING: It is important that your wine rack is assembled correctly. If the unit is assembled or used incorrectly, it could
become unstable and collapse, possibly causing injury.
LIMITED WARRANTY: This product is warranted to be free of material defects, other than that from normal use, for a
period of five years from the date of purchase. Customer's exclusive remedy shall be the repair or replacement of the
defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within
the warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port
Hadlock, WA 98339, postage prepaid within 20 days following a return authorization number (which may be obtained by
telephoning the number at the top of this instructions) being provided to the customer by Enclume. There are no other
warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE PURCHASE OR USE OF ENCLUME'S PRODUCTS
.
Loading...