Enabling Devices Wrist Talker 3037, Wrist Talker 3037B User Manual

For Technical Support:

For Technical Support:For Technical Support:

For Technical Support:

Call our Technical Service Department

Monday through Friday, 9 a.m. to 5 p.m. (EST)

1-800-832-8697

[e-mail]

Wrist Talker 3037 & 3037B

USER’S GUIDE

50 Broadway

Hawthorne, NY 10532

Tel. [phone] / Fax [phone]

Toll Free 800.832.8697

www.enablingdevices.com

Wrist Talker

Easy to wear!

This single message communicator is easy to use.

•Record message of up to 10 seconds

•Great sound quality

•Enables the user to communicate any greeting

•Easy to record and re-record

•Has an adjustable strap
Size: 2¼"D x 1½"H. Requires 3 LR44
Button Cells (Included). Weight: ¼ lb.

Operation:

Operation:Operation:

Operation:

1. Wrist Talker requires 3 LR44 Button cell batteries to operate
(Included). Please Note:

Please Note :Please Note :

Please Note : Before use remove and discard th e round

Before use remove and discard the roun d Before use remove and discard the roun d

Before use remove and discard the roun d

foam

foam foam

foam di sk

diskdisk

disk with hole in the center. This was us ed to p rev ent

with hole in t he center. This was used to preven t with hole in t he center. This was used to preven t

with hole in t he center. This was used to preven t

batt ery dr

batt ery drbatt ery dr

batt ery draining during shipping.

aining duri ng shippin g.aining duri ng shippin g.

aining duri ng shippin g.

To R ecord:

To R ecord:To R ecord:

To R ecord:

2. To make a recording simply twist the cover until the opening lines up
with the gray rubber record button (see illustrations). Next depress
the record button and speak your message from six to eight inches
away from it. When finished recording release the record button. You
have a maximum record time of ten seconds.

To R eplace Batteri es:

To R eplace Batteri es:To R eplace Batteri es:

To R eplace Batteri es:

3. Turn the Wrist Talker over, and then carefully remove the black Velcro
wrist strap (see illustrations). Next with one hand turn the unit back
over, catch the white disk and voice module in your other hand as it
drops out. There are three tabs on the voice module that need to be
depressed in order to replace the batteries. Hold the voice module
with the speaker side facing down. Next with your thumb nail press in
and lift gently on the three tabs on the sides of the cove one at a
time.

4. Please Note:

Please Note:Please Note:

Please Note: On the body of the voice module you will see three
groves, just above them are the tabs you need to depress (see
illustrations). Once this is done the cover should lift off. Observing
proper (+) and (-) battery polarity, install three LR44 button cell

batteries into the holders (+ side facing up). Replace the speaker and
circuit board, making note to line up the grove in the speaker and
circuit board with the grove in the white casing (see illustrations). If
this is not done the unit will not go back together properly.

Message Playback:

Message Playback:Message Playback:

Message Playback:

4. To play back your message slid the cover plate back so that the
microphone is showing through the opening in the cover. Next
depress the center white button.

5. When placing the recording modal back into the wrist holder face the
speaker side towards you. Next place the round disc in place and
feed the wrist strap through both slots. When the wrist talker is on
your wrist the speaker should be facing down towards your wrist and
the message play-back button should be facing up on top.

Troubleshooting:

Troubleshooting:Troubleshooting:

Troubleshooting:
Problem:

Problem:Problem:

Problem: The unit fails to operate, or operates incorrectly.

Action #1:

Action #1:Action #1:

Action #1: Make sure that you have assembled all the parts correctly
according to the instructions and illustration sheet.

Action #2:

Action #2:Action #2:

Action #2: Check your batteries – There is a 99% chance that either one
is installed incorrectly and/or one is weak/dead.

Action #3:

Action #3:Action #3:

Action #3: Disconnect the power by removing one of the batteries for 20
seconds in order to reset the unit. Re-install the batteries. If the unit
does not work correctly, replace all the batteries paying careful attention
to proper polarity.

Care of the Unit:

Care of the Unit:Care of the Unit:

Care of the Unit:
The Wrist Talker can be wiped clean with any household multi-purpose,
non-abrasive cleaner and disinfectant.

Do n ot use

Do n ot useDo not use

Do n ot use abrasive cleaners, as they will scratch the surface of the unit.

Do n ot submerge

Do n ot submergeDo n ot submerge

Do n ot submerge the unit, as it will damage the electrical components.

Rev

Rev Re v

Rev 4444/27

/27/27

/27/17

/17/17

/17