For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
customer_support@enablingdevices.com
Busy Box Traffic Light #1810
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
Teach crossing skills!
Teach crossing skills!Teach crossing skills!
Teach crossing skills!
This innovative wall-mounted light introduces individuals to an
important element in their environment - traffic. The red, yellow or
green light turns on, music plays, and the device vibrates when you
touch each lens. It also provides a tactile and auditory experience
and teaches color recognition. Wall-mounting accessories included.
Size: 26"L x 10½"W. Requires 2 C Batteries. Weight: 4 lbs.
Operation:
Operation:Operation:
Operation:
1. The battery holder is located under the blue cover at the
bottom of the unit. Remove this cover by turning the screws
counterclockwise with a screwdriver. Next remove the small
Phillip’s screw from the battery compartment and slide
cover off. Observing polarity, install two C batteries into the
battery compartment. Alkaline batteries are required
(Duracell or Energizer brands etc.). Do not use rechargeable
or heavy duty batteries because they supply lower voltage
and the unit may not perform as well.
2. Set the ON/OFF slide switch located on the back battery
compartment to ON. Replace both the battery case cover
and blue cover. Snug down the screws, but do not over
tighten.
Troubleshooting:
Troubleshooting:Troubleshooting:
Troubleshooting:
Problem:
Problem:Problem:
Problem: The unit fails to operate, or operates incorrectly.
Action:
Action:Action:
Action: Make sure there are no obstacles or dirt between the
colored plates and the housing of the unit.
Care of Unit:
Care of Unit:Care of Unit:
Care of Unit:
The Busy Box Traffic Light can be wiped clean with any household
multi-purpose cleaner and disinfectant.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit, as it will damage the electrical
components.
Do not use abrasive cleaners
Do not use abrasive cleanersDo not use abrasive cleaners
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
4/3/17
Loading...