Page 1
High Roller - #757
USER’S GUIDE
Page 2
Open the clear dome and place in up to 5 dice. Push the outer rim or add
your capability switch to activate the dice for any dice game you wish to
play. They will shake, rattle and roll! Comes with a white set of dice
and a black set.
Size: 6"L x 6"W x 3.75"H. Requires 2 AA Batteries.
Operation:
1. The High Roller requires two AA batteries. Use alkaline batteries
only (e.g. Duracell or Energizer brand). Do not use rechargeable
batteries or any other type of batteries because they supply lower
voltage and the unit will not perform properly. Never mix old and
new batteries together or different brands or types of batteries
together.
2. Gently turn the unit over to reveal the black battery compartment.
Carefully remove the small screw from the battery compartment
cover using a Phillips head screwdriver, and slide the cover off.
Observing proper (+) & (-) battery polarity, install two AA size
batteries into the holder. Replace the battery compartment cover and
screw.
3. To place your dice in the High Roller, open the clear dome by lifting
up on the Velcro tab. Place up to 5 dice into the tray then close and
secure the dome with the Velcro tab. Now your ready to play your
favorite dice game.
4. The High Roller can be activated two ways. First pressing down on
the clear dome or outer rim. You can also activate the High Roller
through the use of a capability switch (not included). Plug your
switch into the 1/8" jack located on the side of High Roller. Make
sure there are no gaps in the connection. Activating your switch or
pressing on the clear dome/outer rim of the High Roller will make
the dice shake. Once you release your switch or stop pressing down
on the clear dome/outer rim, the High Roller will stop shaking the
dice.
Please Note: The High Roller has no ON/OFF switch. When not in use
or storing the device, make sure that pressure is not applied to the dome
or outer rim. Doing so will cause the High Roller to run non stop and
drain the batteries. We recommend removing the batteries when storing
for long periods of time to prevent this.
Troubleshooting:
Problem: The High Roller does not shake the dice.
Action #1: Rotate (spin) the batteries within the battery compartment to
ensure a good connection. Check that all batteries are installed properly.
Action #2: Check all batteries for freshness, if weak or dead replace
with new batteries. Use an alkaline battery (E.G. Duracell or Energizer
brand).
Action#3: Make sure the High Roller is on a flat smooth and level
surface. Any obstructions under the base will prevent you from
activating the High Roller.
Action#4: Make sure that you have a tight connection between the
external switch and the High Roller. There should be no gaps.
Action#5: Try your external capability switch with another toy/device
to rule out the switch as the source of the problem.
Care of the Unit:
The High Roller can be wiped clean with any mild household multipurpose, non-abrasive cleaner and disinfectant. We recommend Simple
Green, which is a non toxic biodegradable all-purpose cleaner.
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Do not submerge the unit, as it will damage the electrical
components.
Rev 7/28/10
Loading...