Page 1
Vibrating Pillow #460
USER’S GUIDE
Page 2
Ahhh! What a soft, wonderful feeling! Our vibrating pillow is an alltime bestseller. The pillow springs into action when activated by an
external capability switch. The soothing vibration is great for
stimulating tactile awareness, for relieving stress and its fun to play
with, too!
Size: 14" x 10" x 4". Requires 2 D Batteries
Operation:
1. To install the two D batteries, you must locate the zipper on the
back of the Pillow. Next unzip the opening and separate the
opening in the foam pillow to reveal the battery holder. Install the
two D batteries paying close attention to proper (+) and (-)
polarity. When finished zip pillow closed. Please Note: Alkaline
batteries are recommended (e.g. Duracell or Energizer brand) Do
not use rechargeable or heavy duty batteries as they will not work
as well with this device. Never mix old and new batteries together.
2. To use with an external switch, first set the three way Power/
Vibration Speed control switch to the center position, this is the
OFF position. Connect the Vibrating Pillow to any external
capability switch (not included) via the cord jack located at the
back side of the pillow. Vibrating Pillow is equipped with a 1/8"
female mono jack for use with external capability switches that
have a 1/8" mono plug. Make sure you have a tight connection.
There should be no gaps.
3. Actuate your capability switch and Vibrating Pillow will gently
vibrate. Once you release your external capability switch,
Vibrating Pillow will turn off.
4. Vibrating Pillow can also be used without the use of an external
capability switch. Set the three way Power/Vibration Intensity
control switch to either the Low or High vibration Intensity setting.
Vibrating Pillow will continue to run until the switch is turned to
the center off position.
Please Note: When using the Vibrating Pillow with an external
capability switch you cannot change the vibration Intensity setting.
Troubleshooting:
Problem: The Vibrating Pillow does not activate.
Action #1: Make sure that all batteries are installed following proper
(+) and (-) polarity.
Action #2: Replace the batteries with new alkaline batteries (E.G
Duracell or Energizer Brand).
Action #3: Do not use rechargeable or heavy duty batteries.
Care of Unit:
The Vibrating Pillow is surface washable only, it can be wiped clean
with any mild household multi-purpose cleaner and disinfectant. We
recommend Simple Green, which is a non toxic biodegradable allpurpose cleaner.
Do not submerge the unit, as it will damage the contents and the
electrical components.
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Rev 7/27/10
Loading...