Page 1
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-TEC-TOYS or 1-800-832-8697
Switch Spin - #4532
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
Page 2
For Games!
Our switch activated spinner is great for playing games, matching,
rolling dice or making random selections. Just activate your capability
switch and you’re set to play. You can create your own overlays to use
on the spinner. Size: 13"L x 4"W x 14 1/2"H. Requires 2 AA Batteries.
Operation:
1. The Switch Spin requires two AA batteries. The battery
compartment is located on the back of the unit. Carefully turn the
Switch Spin over, and then remove the battery cover with a small
Philips screwdriver. Install new batteries, being careful to
observe proper battery polarity Use alkaline batteries only (e.g.
Duracell or Energizer brand). Do not use rechargeable batteries
or any other type of batteries because they supply lower voltage
and the unit will not perform properly. Never mix old and new
batteries together or different brands or types together.
2. Plug your switch into the jack, making sure there is no gap in the
connection. Activating your switch will make the spinner turn,
once you release your switch the spinner it will stop on one of
the locations.
Troubleshooting:
Problem: The Switch Spin does not activate by your switch.
Action #1: Make sure that the connection between the Switch Spin
and your switch is tight. There should be no gaps. This is a common
error and an easy fix.
Action # 2 Make sure the batteries are in the battery compartment
properly, and making good contact. Replace if weak or dead.
Action 3: Try a different switch with the Switch Spin to rule out this
as the source of the problem.
Action #4: Check that no debris or small objects are blocking the
movement of the spinner.
Care of Unit:
The Switch Spin can be wiped clean with any household multi-purpose
cleaner and disinfectant.
Do not submerge the unit, as it will damage the contents and the
electrical components.
Do not use abrasive cleaners, as they will scratch the surface of the
unit
Rev 7/12/11
Loading...