Page 1
Led Fan #2133
USER’S GUIDE
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
customer_support@enablingdevices.com
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
Page 2
Cool down with our adapted LED fan. With the push of the built in button
or your own switch, set the fabulous light show in motion. The LED lights
create more than 30 different color patterns. Come on a sturdy suction
cup base. Size: 6"L x 3 ¾ "W x 5"H. Requires 3 AAA Batteries. Weight: 6
oz.
Operation:
1.
The LED Fan requires three AAA batteries (not included). Use
alkaline batteries only (e.g. Duracell or Energizer brand). Do not
use rechargeable batteries or any other type of batteries
because they supply lower voltage and the unit will not perform
properly. Never mix old and new batteries together or different
brands or types together.
2.
The battery compartment is located on the back of the fan.
Carefully turn the unit over, and then remove the battery cover
with a small Phillips Head screwdriver. Install new batteries,
being careful to observe proper battery polarity.
3.
You can activate the LED Fan two different ways. One by
pressing the built in switch on the base or connect any capability
switch via the 1/8 inch jack on the side of the base. Make sure
your switch is plugged in all the way, there should be no gaps.
Activate the built in switch or your own switch to set the fabulous
light show in motion. The LED lights create more than 30
different color patterns. Release pressure from your switch and
the lights will stop.
4.
There is also a small push button on the side of the fan, if you
depress this switch the fan will run in continuous play mode. In
this mode the built in switch or an external switch will not control
the LED Fan.
Troubleshooting:
Problem: The LED Fan show does not spin or light up.
Action # 1: Check all Batteries for strength and for proper battery polarity.
Replace if weak or dead.
compartment to ensure a good connection.
Action # 2: Make sure all connections are tight.
Action # 3: Check your switch with another device you know works or try
another switch to rule out the LED Fan as the source of the problem.
Action # 4: If adapters are being used, they must be Mono only stereo
adapters will not work.
Rotate (spin) the batteries within the battery
Care of the Unit:
The
LED Fan
can be wiped clean with any mild household multipurpose, non-abrasive cleaner and disinfectant. We recommend
Simple Green, which is a non toxic biodegradable all-purpose
cleaner.
Do not use abrasive cleaners, as they will scratch the surface of
Do not use abrasive cleaners, as they will scratch the surface of
Do not use abrasive cleaners, as they will scratch the surface of Do not use abrasive cleaners, as they will scratch the surface of
the unit.
the unit.
the unit.the unit.
Do not submerge the unit, as it will damage the electrical
Do not submerge the unit, as it will damage the electrical
Do not submerge the unit, as it will damage the electrical Do not submerge the unit, as it will damage the electrical
components.
components.
components.components.
Rev
Rev 1/5/17
1/5/17
Rev Rev
1/5/171/5/17
Loading...