Re-pinning Cylinder (Optional)
Step 1. Small hole should face down.
Step 2. Rotate key counterclockwise 90º while pressing wire into hole.
For more information
on rekeying cylinder,
please scan the QR
code for how-to video.
Key in Lever Lock Installation Guide
Step 3. Slide lever off stem.
ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and
convenience.
Copyright © 2013, Emtek Products, Inc. an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part
without the express written permission of Emtek Products, Inc. is prohibited.
Installation Guide - For Key in Lever Lock
Lock Assembly
Outside Trim
Door Prep
1/8” Deep
2-3/8”
or 2-3/4”
Backset
Flat spindle
MUST
be in horizontal
position for
installation
Inside Trim
Install Strike Plate
Fasten Strike Plate using Two #8 x 3/4”
Wood Screws (provided).
IMPORTANT!
CHECK LATCH HUB POSITION
BEFORE INSTALLING
2⅜” Backset
Correct Hub Position
2⅜” Backset
Wro ng Hub Position
2¾” Backset
Correct Hub Position
2. Remove Inside Rosette
Step 1. Remove inside lever by loosing
set screw w/ hex wrench (provided).
1. Adjust and Install Latch
Step 1. Adjusting for appropriate backset.
Plastic
Latch Pin
Plastic Latch Pin
The Adjustable Latch is factory shipped with a
2-3/4” backset position. Remove pin and slide
spindle hub forward for a 2-3/8” backset, then
!
reinsert the pin in the hole at the back of the
latch as shown.
Step 2. Fasten Adjustable Latch using two #8 x 3/4” Wood
Screws (provided).
To remove Pin:
Push Plastic Latch Pin
through latch with
screwdriver.
3. Installing Inside Trim
Step 1. Secure inside rosette to door by threading it clockwise on
to stem.
2-1/4”
1 “
1” Diameter
Edge Bore
2-1/8”
Dia.
Bore
Scan this
QR code for
installation
video
Step 2. Unthread rosette
counterclockwise to remove from
housing before installing on door.
IN4-KEYNLEVER
Plunger spindle
MUST
be in horizontal
position for
installation.
Step 2. Tighten lever set screw after placing lever on stem.
Rev. 02/26/2013
Loading...