Emtek Key In Lever with Rosette User Manual

Installation Guide - For Key in Lever Lock with #8 Style Rosette

Lock Assembly

Outside Trim

Flat spindle

MUST

be in horizontal

position for

installation

Door Prep 2. Install Adjustable Latch1. Install Strike Plate

Fasten Strike Plate using

⁄” Deep

2 ⁄”

Two #8 x 3/4” Wood Screws
(provided).

or 2 ¾”
Backset

Fasten Adjustable Latch using two
#8 x 3/4” Wood Screws (provided).

To remove Pin:
Push Plastic Latch Pin
through latch with
screwdriver.

Re-pinning Cylinder (Optional)

Step 1. Small hole should face down.

For more information on rekeying
cylinder, please scan the QR code for
how-to video.

2 ¼”

2 ⁄”

1 “

Inside Trim

Step 2. Rotate key counterclockwise 90º while
pressing wire into hole.

Step 3. Slide lever off stem.

1” Diameter
Edge Bore

Dia.
Bore

Scan this

QR code for

installation

video

3. Remove Inside Rosette

Step 1. Remove inside lever by

loosing set screw w/ hex wrench
(provided).

Step 2. Unthread rosette
counterclockwise to remove from
housing before installing on door.

!

The Adjustable Latch is factory shipped with a 2¾”
backset position. Remove pin and slide spindle hub
forward for a 23/8” backset, then reinsert the pin in
the hole at the back of the latch as shown.

Plastic

Latch Pin

Plastic Latch Pin

4. Installing Inside Trim

Step 1. Secure inside rosette to door by threading it

clockwise on to stem.

Plunger spindle

MUST

be in horizontal

position for

installation.

Spanner
wrench
(provided).

Step 2. Tighten lever set screw after placing lever
on stem.

10-22-2012 IN4-KEYNLVR8