Emtek Key In Knob with Rosette User Manual

Installation Guide - For Key in Knob with #8 Style Rosette

Lock Assembly

Outside Trim

Flat spindle

MUST

be in horizontal

position for

installation

Door Prep 2. Install Adjustable Latch1. Install Strike Plate

Fasten Strike Plate using

⁄” Deep

2 ⁄”

Two #8 x 3/4” Wood Screws
(provided).

or 2 ¾”
Backset

Fasten Adjustable Latch using two
#8 x 3/4” Wood Screws (provided).

To remove Pin:
Push Plastic Latch Pin
through latch with
screwdriver.

Re-pinning Cylinder (Optional)

Step 1. Small hole should face down.

For more information on rekeying
cylinder, please scan the QR code for
how-to video.

2 ¼”

2 ⁄”

1 “

Dia.

Bore
1” Diameter
Edge Bore

Inside Trim

Step 2. Rotate key counterclockwise 90º while
pressing wire into hole.

Step 3. Slide knob off stem.

Scan this

QR code for

installation

video

3. Remove Inside Rosette

Step 1. Remove inside knob by

loosing set screw w/ hex wrench
(provided).

Step 2. Unthread locking ring
counterclockwise to remove
rosette from housing before
installing on door.

The Adjustable Latch is factory shipped with a 2¾”
backset position. Remove pin and slide spindle hub
forward for a 23/8” backset, then reinsert the pin in
the hole at the back of the latch as shown.

Plastic

Latch Pin

Plastic Latch Pin

4. Installing Inside Trim

Step 1. Secure inside rosette to door by threading

locking ring clockwise on to stem.

Plunger spindle

MUST

be in horizontal

position for

installation.

!

Spanner
wrench,
(provided).

Step 2. Tighten knob set screw after placing knob on
stem.

10-22-2012 IN4-KEYNKNB8