Installation Instructions - Pocket Door Mortise Lock
See included template for door prep specifications
Drill two 1/8” pilot holes
7-1/8” apart on center.
Install lock body into door.
Inside Trim
Thread Drive Bar Cylinder into lock body.
NOTE: Drive Bar Socket must be in the
12 o’clock position as shown.
Note: Install
inside cover last.
Drive bar
socket
Note: Notch on cylinder must be in the 9 o’clock
position when fully screwed into lock body.
Outside Trim
Note: Key Cylinder notch must be at the
3 o'clock position when fully screwed in lock body.
Note: Outside cover must
be installed before cylinder.
After threading both inside & outside cylinders into
lock body, tighten locking screw counter clockwise
to engage notches on both cylinders.
NOTE: DO NOT OVER TIGHTEN SCREW.
Door Jamb Prep.
Drill two 1/8” pilot holes for wood screws provided).
IN4-POCKETMORTISE
REV. 5/27/09
Loading...