Emtech Electronics BLU-CS User Manual

Sig

BLU-CS Satellite Control

The BLU-CS is a satellite audio control
for BSS Audio London Series Digital

nal Processors. It is build on a

decora style panel for mounting in a
single gang electrical box. The front
side of the control has a lighted
momentary pushbutton switch for
turning on the satellite audio, and a pot
for adjusting the volume of the audio
signal. On the backside of the control
is a single RJ-45 Cat5e connector for
connecting the BLU-CS to the DSP.

BLU-CS Wiring Instructions

IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be

crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.

You must crimp and test the wiring with an approved CAT5 568A/B
tester before connecting any cable between the BLU-CS and either a
BLU-CIF or BLU-IF Interface unit. Failure to crimp wiring to the correct

standard could possibly lead to component damage.

EIA/TIA568B

1. White-Orange

2. Orange

3. White-Green

4. Blue

5. White-Blue

6. Green

7. White-Brown

8. Brown

1 8

(Key on bottom)

BLU-CS RJ-45 Pinouts

1. Power Button (Logic Input)

2. Volume (Logic Input)

3. Ref Voltage (+5V)

4. Not Used

5. Not Used

6. Power Button LED (Logic Output)

7. GND (C)

8. GND (C)

Backside of BLU-CS