Emtech Electronics BLU-CC User Manual
The BLU -CC2 is a 3-input (3-mic or
3.5mm) to the DSP.
BLU-CC2 Remote Control
BLU-CC Wiring Instructions
2-mic & 1-transformer balanced stereo
to mon o line input) remote control for
BSS Audio London Series Digital
Signal Processors. It is housed in a 3-
gang wall m ountable box with a
latching do or. On the backside of the
cont rol, t here is a p air of R J-45 Cat5e
connector s for c onnecting the BLU CC2 to the DSP, and a 3-pin Euroblock for the audio signal from either
Mic 3 or the Aux Inputs (RCA or
IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be
crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.
You must crimp and test the wiring with an approved CAT5 568A/B
tester before connecting any cable between the BLU-CC and either a
BLU-CIF or BLU-IF Interface unit. Failure to crimp wiring to the co rrect
standard could possibly lead to component damage.
EIA/TIA568B
1. White-Orange
2. Orange
3. White-Green
4. Blue
5. White-Blue
6. Green
7. White-Brown
8. Brown
Backside of BLU-CC
MODE 1 PIN OUTS
1 8
CC2 RJ-45 Pin outs
Mic 3/Aux Output Connector (see next page)
(Key on bottom)
-IMPORTANT-
In addition to adding a 3.5mm stereo jack to the AUX Inputs section of the
BLU-CC2, there is a switch on the upper back of the board for setting up the
BLU-CC2 in e ither Mode 1 for a s yst em using a new BLU-CIF/BLU-CIF2,
or Mode 2 for a system using a n old BL U-CIF.
Setting up a BLU-CC 2 in
Mode 1 in conjunction with a
new BLU-CIF or BLU-CIF2
requ ires a new template, which
is available from BSS Audio.
RJ-45 Pin outs (has LED indicator)
CC1
1. Source (Logic Input)
2. Volume 1 (Logic Input)
3. Ref Voltage (+4.3V)
4. Not Used
5. VCC
6. Pow er Enable
7. SIG GND (C)
8. PWR GND (C)
1. Volume 2 (Logic Input)
2. Volume 3 (Logic Input)
3. Ref Voltage (+4.3V)
4. res erved for Mode 2
5. Not Used
6. res erved for Mode 2
7. SI G GND
8. PW R GN D
Loading...