EmSense 4011102 User Manual

Step 1 – Unpack and set up EmBand.

Grab the pull tab and remove headset contents from
sleeve. Pull the EmBand packing out of the sleeve.
Unfold and follow the directions on the printed side of
the packing.

Step 2— Begin using the EmBand

Open the Email received from testing company. Follow
the directions in the Email to begin testing.

Step 3 – Storing the EmBand

Remove the battery before storage. Coil the cable from
the USB extender so that it fits into the insert. Place the
EmBand and accessories into the foam insert locations
and slide the insert into the sleeve for safe storage.

To clean the EmBand, wash the surface with soap and
water or alcohol. Do not submerge in water.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.

Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate
the EmBand.

This device complies with the criteria published by the
American National Standards Institute (ANSI) for
localized specific absorption rate (“SAR”) in Section 4.2
of “IEEE Standard for Safety Levels with Respect to
Human Exposure to Radio Frequency Electromagnetic
Fields, 3 kHz to 300 GHz,” ANSI/IEEE C95.1–1992,
Copyright 1992 by the Institute of Electrical and
Electronics Engineers, Inc., New York, New York 10017.

This device contains an LED device that emits infrared
light that is not visible to the human eye. This device
meets the IEC 60825-1 and IEC 62471 safety
requirements for LED devices.

For questions and further information contact:

[e-mail]