Mini Dongle Pairing Procedure
for ARF Series Keyboard & Mouse
Version 1.0
Mouse connect button and power switch location
Connect Button
Power Switch
Pairing button on the bottom of the mouse
Important:
The pictures show above are just for reference.
Checking exact location if it is not the same as your model.
(With an LED under the pairing button)
Keyboard connect button location
ID connection button
Dongle connect button location
Pairing button on the top of the receiver
Important:
The pictures show above are just for reference.
Checking exact location if it is not the same as your model.
Pairing Instructions
Step 1: Mouse preparation
1. Switch mouse off
2. Insert batteries into mouse
3. Make sure polarity of batteries is correct
4. Switch mouse on
Step 2: Keyboard preparation
1. Insert batteries into keyboard
2. Make sure polarity of batteries is correct
Step 3: Dongle preparation
Put dongle in a free USB port on your computer or on a USB cable connected to your computer.
Make sure the dongle connect button is easy to reach.
Step 4: Pairing mouse and dongle
1. Pressing connect button on dongle over 2 seconds until dongle LED start flashing.
2. When dongle LED is still flashing, holding down mouse connect button over 2 seconds.
3. Mouse and dongle should be close together within 30cm of each other when pairing
4. Dongle LED will stop flashing on successful pairing, or LED will also stop flashing automatically
after 1 minute.
Step 5: Pairing keyboard and dongle
1. Pressing connect button on dongle over 2 seconds until dongle LED start flashing.
2. Important: When dongle LED is still flashing, holding down any one key on the keyboard and
connect button together in order to pair keyboard and dongle. E.g. pressing F12 key on the top
of the keyboard and keep holding connect button together at the back of the keyboard over 2
seconds until keyboard battery low LED flashes once if your keyboard model has such indicator.
3. Keyboard and dongle should be close together within 30cm of each other when pairing .
4. Dongle LED will stop flashing on successful pairing, or LED will also stop flashing automatically
after 1 minute.
Loading...