52X DDS CD-RW Drive
Dual Digital Storage
7 in 1 card reader compatibility
User’s Manual
DANGER INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM
VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT
DEM STRAHL AUSSETSEN
ATTENTION RADIATION DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE.
EVITER TOUTE EXPOSITION AUX RAYONS.
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
LASER KLASSE 1
LUOKAN 1 LASERLAITE
PRODUIT LASER
CATEGORIE 1
Copyright Statement
It is a criminal offence, under applicable copyright laws, to make unauthorised
copies of copyright-protected material, including computer programs, films,
broadcasts and sound recordings. This equipment should not be used for such
purposes.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can emit radio frequency energy
and, if not installed or used in accordance with the instructions, may cause
interference to radio communications. However, television reception interference
can be determined by turning the equipment off and on. The user is encouraged to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet different from that to which the receiver
is connected
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FOR EUROPE
“The drive is in conformity with the EMC directive and low-voltage
directive.”
Table of Contents
INTRODUCTION 1
SYSTEM REQUIREMENTS 2
PACKAGE CONTENTS 2
INSTALLATION 3
HOST INTERFACE CONNECTIONS 3
HARDWARE INSTALLATION 4
SOFTWARE INSTALLATION 6
Windows Environment 6
CONNECTION & OPERATION 7
FRONT PANEL 7
REAR VIEW 9
TECHNICAL DATA 11
52X DDS CD-RW Drive
INTRODUCTION
Thank you for the purchase of this perfect and compact dual digital storage
drive with the combination of an IDE CD-ReWritable drive and a USBconnected card reader.
This drive backs up all writing modes and different CD formats. It supports
maximum 52x speed writing ability on CD-R discs, 32x speed on CD-RW
discs and 52x speed reading performance. Other than that, the built-in 7 in
1 card reader which offers read-write capabilities of 7 memory card types
simplifies the process of exchanging data between digital cameras, voice
recorders, PDAs, MP3s… and your computer.
With this multi-functional solution and the bundled software package, you
can view, archive, or write files/photos/video/music directly from the drive
and enjoy the fascinating digital entertainment on your desktop.
Here are some important features:
♦ Easy installation with CD-RW drive of EIDE and card reader of USB
2.0 interface (on-board connection)
♦ 8X, 16X, 24X, 32X, 40X, 48X and 52X writing speed on CD-R media
♦ 4X, 10X, 12X, 16X, 20X, 24X and 32X writing speed on CD-RW
media
♦ Adopts “MTKSuperLink” to prevent Buffer Underrun
♦ Supports MultiRead function
♦ Supports writing modes of TAO, DAO, SAO and packet writing
♦ Four-slot integration of the card reader works with CompactFlash,
MicroDrive, Memory Stick, Memory Stick Pro, MultiMediaCard,
Secure Digital, and SmartMedia
♦ Convenient connection with A-Type USB Extension Port on the front
panel
1
52X DDS CD-RW Drive
System Requirements
For IBM compatible PCs, the system requirements recommended are as
follows:
♦ Pentium II 350MHz above with at least 64MB of memory
♦ Fast and sufficient hard disk space (minimum 200MB for installation,
1GB or more is recommended.)
♦ IDE host interface supporting ATAPI MMC command & USB host
interface (if you don’t have USB on-board connection)
♦ Operating system: Microsoft Windows 98SE/ME/2000/XP
Package Contents
♦ 52X DDS CD-RW Drive
♦ Audio cable
♦ Application software disc
♦ Quick Installation Guide
2
52X DDS CD-RW Drive
INSTALLATION
Host Interface Connections
Most current motherboards have two IDE ports (primary and secondary)
which can connect two IDE cables. Two IDE cables allow you to connect
up to four devices, but it is recommended that you separate IDE ports for
your hard disk and your CD-ReWritable drive. This will ensure that your
hard disk’s performance and speed won’t be affected by having the CDRW drive on the same cable.
Master
Slave
Cable Select
If you connect only one device on the cable, you can set the jumper as
“MASTER” or “SLAVE”.
If you connect two devices (e.g. CD-ROM & CD-RW) on the same cable,
set different jumpers for each device (CD-ROM as “MASTER”, CD-RW as
“SLAVE” and vice versa.) The same rule applies to the connection of
having your hard disk and another device on the same cable.
Cable Select
Slave
Master
Jumper
3
52X DDS CD-RW Drive
Hardware Installation
1. Turn off the power to the computer system.
2. Disconnect the power cord and all cables from the back of your
computer, and then remove the cover of the computer.
3. Insert the drive into one of the vacant 5.25" drive bays and secure it
with screws to your PC.
4. Connect one end of the 40-pin IDE cable to the IDE connector of this
drive and the other end to the IDE port on your motherboard. Also,
connect the power supply cable to the back of the drive.
Audio Out
Digital
Audio Output
Power In
red edge
Make sure to align and connect the red-edge of the IDE Cable to Pin
1 on the drive.
5. If you have a sound card that can be connected to this drive, you can
connect the drive (as Audio-out) and the sound card (as Audio-in)
with a 4-pin audio cable.
If your motherboard is integrated with built-in sound system, plug the
4-pin audio cable into the CD-IN connector on the motherboard as
Audio-in.
4
52X DDS CD-RW Drive
6. Connect the USB cable at the back of the drive to the USB header
on the computer’s motherboard. The red wire of the cable needs to
be plugged into Pin 1 on the board.
This drive supports USB 2.0 and if you connect to USB 1.1
connector, only transfer rate of USB 1.1 will be available.
Mother
Board
Signal
Red/Vcc
White/DGreen/D+
Black/Ground
Braided Shield Ground
Error-Proof Pin
Pin#
1 / 6
2 / 7
3 / 8
4 / 9
5
10
IDE
Red Wire
USB Header
USB
Red Wire
Error-Proof Pin
If the connection is correct, the lower right LED on the front panel
will light green.
7. Re-attach the cover of your computer, and reconnect the power
cord and all cables.
5
52X DDS CD-RW Drive
Software Installation
The bundled mastering software gives you the complete solution for
making audio/data CDs. With the user-friendly interface, it guides you
through the creation and backup of files/photos/video/music from your
computer to a recordable compact disc. Combining of the card reader
capabilities, no matter you are a novice or an experienced user; you can
enrich your digital life with this best recording tool.
Windows Environment
1. Insert the application CD and the installation program will run
automatically. Then follow the on-screen procedures.
Or
2. Run:\setup.exe on the application CD.
6
52X DDS CD-RW Drive
CONNECTION & OPERATION
Front Panel
4
5
10
1
1. A-Type USB Extension Port
This USB port is Plug-and-Play Ready. Just plug your USB device
and the computer will detect automatically.
2. Close/Eject Button
This button opens and closes the disc tray. If the tray is closed,
pressing the button will eject it.
3. LED Indicator (the CD-RW drive)
Flashes “green” while verifying or reading a disc.
Flashes “amber” while writing a CD-R/CD-RW disc.
4. Disc Tray
Place the disc in the tray here, and then press the Close/Eject button
or lightly push the tray to close it.
6
2
7
3
89
11
7
52X DDS CD-RW Drive
5. Emergency Eject Hole
When the Close/Eject button doesn’t work properly and the disc tray
can’t be opened, you can insert a paper clip or a small rod into this
hole for manual ejection. Please make sure to power off the system
before you do that.
6. Slot for Memory Stick (MS)/Memory Stick Pro (MS Pro)
7. Slot for Secure Digital (SD)/MultiMediaCard (MMC)
8. Slot for Compact Flash (CF) Type I, II/MicroDrive
9. Slot for Smart Media
10. LED Indicator (the Card Reader)
When the data of the memory card is being accessed, the LED
flashes red.
11. LED Indicator (the Card Reader)
Once the USB cable is correctly connected, this LED will light green,
which means the card slots are ready to use.
NOTE: The front panel is subject to change without notice.
8
Rear View
52X DDS CD-RW Drive
23 4
5
6
1. Digital Audio Output Connector
If your sound card has a digital audio IEC958 format connector, you
can connect it to this digital audio output connector with a 2-pin
audio cable.
2. Analog Audio Output Connector
This connector allows you to connect the drive to your sound card
with a 4-pin audio cable.
3. Device Configuration Jumper
Set the jumper to Master, Slave or Cable Select according to your
system configuration.
4. IDE Interface Connector
Plug one end of the 40-pin IDE cable here to join the 40-pin IDE
connector on the motherboard. The red-edge of the IDE cable must
be connected to Pin 1 of each connector.
5. Power Supply Connector
By plugging the computer’s power supply cable here, you can
connect the drive and your computer system.
9
52X DDS CD-RW Drive
6. USB Cable
Connect the USB cable to the USB connector on the motherboard.
The red wire of the cable needs to be plugged into Pin 1 on the
board.
10
52X DDS CD-RW Drive
TECHNICAL DATA
Interface CD-RW Drive: EIDE
Card Reader: USB 2.0
Form factor 5.25" Half Height
Writing speed CD-R:
8X/16X/24X/32X/40X/48X/52X
CD-RW:
4X/10X/12X/16X/20X/24X/32X
Writing modes TAO (Track at once), DAO (Disc
At Once), SAO (Session at once),
Multi-session, Packet Writing
Digital Media CompactFlash, MicroDrive, Memory
Stick, Memory Stick Pro, SmartMedia,
MultiMediaCard, and Secure Digital
CD format support CD-DA, CD-ROM, CD-ROM XA, CD-I,
Photo CD, CD-TEXT, Video CD, CDExtra, CD-R, CD-RW, CD-UDF
Transfer rate
CD-RW Drive Read:
CD-ROM/CD-R:
7800KB/s (up to 52X)
CD-RW: 4800KB/s (up to 32X)
Write:
CD-R 7800KB/s (up to 52X)
CD-RW 4800KB/s (up to 32X)
Card Reader 480Mb/s (USB 2.0)
Data buffer 2MB
11
52X DDS CD-RW Drive
Access time 90ms at ⅓ stroke(52X CD-ROM)
180ms at full stroke(52X CD-ROM)
99ms at ⅓ stroke (32X CD-RW)
200ms at full stroke (32X CD-RW)
Disc loading Tray (motorised), Dust Sealed
Audio output level Line out = 0.6 ± 10%Vrms
Power 5 VDC & 12VDC
Card Reader power directly from
computer power supply through USB
connection
Dimensions
Height 41.8 ± 0.2 mm
Width 148.6 ± 0.2 mm
Depth 193.3 ± 0.3mm
Weight 1 kg
Disc Specification
Capacity
120mm disc: 74min 650MBytes Mode-1
80min 700MBytes Mode-1
90min 800MBytes Mode-1
80mm disc: 18min 158Mbytes Mode-1
21min 184MBytes Mode-1
12
Environment
Temperature
Operating 5°C to 45°C
Non-operating -20°C to 60°C
Humidity
Operating 8% ~ 80%RH
Non-operating 5% ~ 95%RH
52X DDS CD-RW Drive
13
3100552210
Version 1.2
April 2004
Loading...