eMotimo Integration Kit for Dana Dolly Instruction Manual
eMotimo Integration Kit for Dana Dolly
Instruction Manual
V 1.1
eMotimo Dana Dolly integration instructions
1
Contents:
Your Dana Dolly kit & identifying orientation
What’s included
General principles / mounting
#1 Mounting for original track ends, round track, bottom up
#2 Mounting for original track ends, round track, top up
#3 Mounting for original track ends, triangle track, bottom up
#4 Mounting for original track ends, triangle track, top up
#5 Mounting for universal track ends, round track, top up
#6 Mounting for universal track ends, round track, bottom up
#7 Mounting for universal track ends, triangle track, top up
#8 Mounting for universal track ends, triangle track, bottom up
03
04
05 - 07
08
09
10
11
11
13
14
15
eMotimo Dana Dolly integration instructions
2
What Dana Dolly kit do you have?
Universal track ends
Top up
Original track ends:
Top up
Bottom up
Bottom up
Round track:
Triangle track:
eMotimo Dana Dolly integration instructions
3
What Is Included in the eMotimo Integration Kit:
2.3
2.4
2.5
1.7
1.8
1.9
2.22.2
2.12.1
1.3
1.4
1.5
1.6
1.2
4
3
1.1
Part Names
1. Motor Mount
1.1 - Carriage Mount & Motor
1.2 - Motor cable / plug
1.3 - Idler/belt adjustment thumbscrew
1.4 - 1/4-20” athead screw
1.5 - 1/4-20” metal washer
1.6 - 1/4-20” rubber washer
1.7 - 3/8-16” athead screw
1.8 - 3/8-16” metal washer
1.9 - 3/8-16” rubber washer
2. Belt Clamp (two included)
2.1 - Belt clamp base
2.2 - Belt clamp tensioner
2.3 - Clamp base thumbscrew
2.4 - Belt tensioner thumbscrew
2.5 - Belt tensioner washer
3. Belt
4. eMotimo Clamp Riser
eMotimo Dana Dolly integration instructions
4
General Principles:
Carriage mounting: Belt routing:
1. Align Motor Mount over 1/4” and 3/8”
through holes on the Dana Dolly.
2. Mount Motor Mount to Dana Dolly using the
1/4-20” and 3/8-16” hardware in the following
order (starting with Dana Dolly):
1) Carriage Mount & Motor
2) 1/4-20” and 3/8-16” rubber washers
3) 1/4-20” and 3/8-16” metal washers
4) 1/4-20” and 3/8-16” athead screws
3
1
4
2
Always route belt over pulley with teeth down.
Wrap under both idlers.
Belt alignment: Belt clamp orientation
Manually slide the dolly towards the belt
clamp to check alignment. Align clamp with
the edge of the belt by sliding it left or right
on the end bracket. Tighten down at the
bottom of the clamp the with 1/4-20 clamp
thumbscrew to lock the clamp in place.
Always mount clamps with thumbscrews facing
outwards.
eMotimo Dana Dolly integration instructions
5
Loading...