Eminence DELTA-10B User Manual

Specification

dBSPL

Ohm

Nominal Basket Diameter Nominal Impedance* Power Rating** Watts Music Program Resonance Usable Frequency Range*** Sensitivity Magnet Weight Gap Height Voice Coil Diameter

Thiele & Small Parameters

Resonant Frequency (fs) DC Resistance (Re) Coil Inductance (Le) Mechanical Q (Qms) Electromagnetic Q (Qes) Total Q (Qts) Compliance Equivalent Volume (Vas) Peak Diaphragm Displacement Volume (Vd) Mechanical Compliance of Suspension (Cms) BL Product (BL) Diaphragm Mass inc. Airload (Mms)

Efciency Bandwidth Product (EBP)

Maximum Linear Excursion (Xmax) Surface Area of Cone (Sd) Maximum Mechanical Limit (Xlim)

Mounting Information

Recommended Enclosure Volume Sealed Vented Overall Diameter

Bafe Hole Diameter

Front Sealing Gasket Rear Sealing Gasket Mounting Holes Diameter Mounting Holes B.C.D. Depth Net Weight Shipping Weight

9.90-12.70 liters/0.35-0.45cu.ft.

10.80-34.00 liters/0.38-1.20 cu.ft.

Materials of Construction

Copper voice coil Polyimide former Ferrite magnet Vented core Pressed steel basket Paper Cone Cloth cone edge Solid composition paper dust cap

10”, 254mm

16 ohms

350W

700W

65Hz

71Hz-3.70kHz

98.00

56 oz.

0.37”, 9.53mm

2.50”, 63.50mm

65Hz

11.60

0.79mH

8.34

0.35

0.33

36.00 liters / 1.27 cu.ft.

62.00cc

0.21mm/N

19.50 T-M 28 grams

186.00

1.80mm

344.90 cm2 9mm

10.09”, 256.20mm

9.18”, 233.17mm

Fitted as standard Fitted as standard

0.25”, 6.40mm

9.66”, 245.40mm

4.25”, 108mm

10.80 lbs., 4.90 kg

12.00 lbs., 5.40 kg

DELTA-10B American Standard Series

Recommended for professional audio and bass guitar applications as a woofer/mid-bass or mid-range in vented monitors, satellites and multi-way enclosures.

105

100

20 Hz50100 200500 1K 2K 5K 10K20K

Please inquire about alternative impedances.

Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.

The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.

***

Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software

calibrated) mounted 1m from wall/bafe | 2ft. X 2ft. bafe is built into the wall with the speaker mounted ush against a steel ring for minimum diffraction | Haer P1500 Trans-Nova amplier | 2700 cu.ft. chamber with

berglass on all six surfaces (three with custom-made wedges)

200

100