EMG B234rB Installation Information
PO BOX 4394
6
SANTA ROSA, CA
95402 USA
0230-0283rC
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
INSTALLATION INFORMATION
EMG MODEL: B234rB STACKED VOLUME CONTROLS
OR STACKED VOLUME/TONE CONTROLS
(ACTIVE PICKUP INPUT 25K OHM, BLACK PC BOARD)
General Operation
The B234rB is a stacked (concentric) set of 25K Ohm controls for EMG Active Pickup Systems. The top control functions as a volume control,
while the bottom control can be either another volume control, or by installing a shorting plug it can become a tone control. Examples are shown
in the included diagrams. The B234rB features plug-in compatibility with all EMG Pickup Systems. If necessary, you can solder existing pickup
cables to the wiper and ground contacts on the PC Board. If you need left handed operation (CCW) then contact EMG directly and we can supply
one for you. Also available is the B258rA-HZ for passive pickups (Green PC Board).
Schematic Diagram:
B234rB Controls
(Both controls have a similar pinout)
.700
.875
IN/OUT
GND
IN/OUT
GND
IN/OUT
GND
1
2
3
4
5
6
1
2
3
4
5
6
VIEWED LOOKING AT
CONNECTOR PINS
CW
W
A25K
CCW
The EMG coax cables for wiring the guitar are a 2-pin pair,
The signal or “Hot” wire is White, the Ground (Shield) wire is Black.
1.000
.350
.320
.155
BOTTOM
CONTROL
TOP
CONTROL
The B234rB has solder pads that can be used
if you do not have connectors on the pickup
cables.
Pickup Cable
Pickup Cable
Solder Pickup Braids to GND Pads
Solder Pickup Hots to Input Pads
SCHEMATIC NOTES:
The Schematic diagram above shows how each B234 Volume control is configured.
Pins 1 and 2 are the input or output of the CW (Clockwise) terminal of the control.
Pins 3 and 4 are the input or output of the W (Wiper) terminal of the control.
Pins 5 and 6 are duplicates of pins 1 and 2, the CW terminal (Clockwise).
Pins 2, 4, and 6 go directly to ground, the CCW (Counter-Clockwise) terminal of the control is grounded.
© 2013 Copyright EMG INC. All Rights Reserved.
5
4
3
Installation Instructions:
EMG Model: B234rB Stacked Volume or Volume/Tone (25K)
The B234rB has two controls that can be configured as two volume controls
or as a volume/ tone combination. Only the “B” Bottom Control can be used
as a tone control. The PC Board is marked with a “B” for the Bottom control
(larger outside control shaft) and “T” for the Top Control with the smaller, inner shaft.
The controls can be daisy-chained to produce a single output.
Both controls are 25K Ohm (Audio Taper) and are designed to work with EMG Active Pickups,
The diagrams included assume you have two pickups installed in your instrument.
Diagram #1
If you are using the two controls as volume controls the pickup inputs should be connected
to the “wiper” contacts of the pots, the middle two contacts.
Using the Wipers as the inputs will allow the controls to work independently of one another.
As shown in the diagram the output of each control comes from pins 5 and 6 on the left side
of each 6 pin header, they can also come from pins 1 and 2 which ever pair is more convenient.
Pins 1 and 2 are the same as pins 5 and 6.
Diagram #2
To use the Top control as a Volume and the Bottom control as a Tone Control simply install the
blue shunt onto the terminals as shown to the right. A capacitor has been pre-installed on the
circuit board. Once the shunt is in place it won’t be necessary to plug any
contacts onto the “B” 6 pin header. The shunt does all the work.
Assuming there are two pickups in your instrument, when you use
either tone control, both pickups will be effected. This is common
with passive style controls.
Diagram #1
Pickup Outputs (Pins 5 & 6)
or (Pins 1 & 2))
Top and Bottom
Diagram #2
Pickup Input
Pickup Output
2
1
Pickup Inputs (Pins 3 & 4)
Top and Bottom
6
5
4
3
2
1
Diagram #3
Daisy Chained
Volume Tone / Volume Tone
NECK PICKUP
BRIDGE PICKUP
Diagram #4
Stacked Volume / Volume
Master Tone
- 9V +
BATTERY
BUSS
OUTPUT CABLE
BATTERY
BUSS
R
S
T
OUTPUT
B234rB Page 2
BRIDGE PICKUP
NECK PICKUP
- 9V +
LOOPED CABLE
BOTTOM TO TOP
(B) BOTTOM CONTROL
BRIDGE PICKUP VOLUME
TONE
B124rH
TONE
OUTPUT CABLE
(T) TOP CONTROL
NECK PICKUP VOLUME
R
S
T
OUTPUT
Loading...