Emerson SLCASA-CVR User Manual

Power Supply

Chassis

Self-tapping screws (2 qty)
M3x6 mm

Plastic screws (2 qty)
M3x6 mm

*Must use plastic only

Part A Cover

*

*

FIGURE 1

Part A Cover

SLO-12-000-TB

FIGURE 2

Linear Power Cover Instruction Manual Model Number: SLCASA-CVR

Power Supplies Affected

SLS-05-030-1T, SLS-12-017T, SLS-24-012T

What’s Included

• Part A Cover

• Two Plastic Screws M3x6 mm

• Two Self-tapping Screws M3x6 mm

• Instruction Manual

Assembly Instructions for Cover Installation

Assembly Instructions for OVP

1. Locate the mounting holes as shown in Figure 2.

2. Attach SLO-12-000-TB tightly against the inner side of the cover.

3. Position the mounting holes and tighten the screws with 8 kg torque.

4. Assemble the two wires coming out of the SLO-12-000-TB. On the terminal

block, the white wire goes to the “+” and the black wire goes to the “-”.

1. Position the Part A Cover so that it overlaps the exterior surface of the

Power Supply Chassis.

2. Line up the Part A Cover mounting holes with the Power Supply Chassis

mounting holes. Be careful not to pinch the wires.

3. Secure with the provided screws as shown in Figure 1.

Notes

1. Be careful while assembling the cover, so that no parts on the PCB are

damaged.

2. When tightening the screws, make sure the torque is 8 kg.

3. Derate power supply by 15% with cover installed.

Technical Support

U.S.: [phone]
International: [phone]
E-mail: [e-mail]

Part Number: A272-108 Rev 3

September 22, 2008

Part B Cover

Self-tapping screws (2 qty)
M3x6 mm

Plastic screws (2 qty)
M3x6 mm

*Must use plastic only

*

*

Power Supply Chassis

FIGURE 1

SLO-12-000-TB

Part B Cover

FIGURE 2

Linear Power Cover Instruction Manual Model Number: SLCASB-CVR

Power Supplies Affected

SLS-05-060-1T, SLS-12-034T, SLS-24-024T

What’s Included

• Part B Cover

• Two Plastic Screws M3x6 mm

• Two Self-tapping Screws M3x6 mm

• Instruction Manual

Assembly Instructions for Cover Installation

Assembly Instructions for OVP

1. Locate the mounting holes as shown in Figure 2.

2. Attach SLO-12-000-TB tightly against the inner side of the cover.

3. Position the mounting holes and tighten the screws with 8 kg torque.

1. Position the Part B Cover so that it overlaps the exterior surface of the

Power Supply Chassis.

2. Line up the Part B Cover mounting holes with the Power Supply Chassis

mounting holes. Be careful not to pinch the wires.

3. Secure with the provided screws as shown in Figure 1.

4. Assemble the two wires coming out of the SLO-12-000-TB. On the terminal

block, the white wire goes to the “+” and the black wire goes to the “-”.

Notes

1. Be careful while assembling the cover, so that no parts on the PCB are

damaged.

2. When tightening the screws, make sure the torque is 8 kg.

3. Derate power supply by 15% with cover installed.

Technical Support

U.S.: [phone]
International: [phone]
E-mail: [e-mail]

Part Number: A272-109 Rev 3

September 22, 2008