Emerson IS-WEBRT3 User Manual

Liebert® IS-WEBRT3 Card

Control
functions

Liebert
IS-WEBRT3
cards found

™

Quick Start Guide

I

NSTALL

• Locate the Liebert IntelliSlot bay on your Liebert equip­ment. You might need to remove a plastic cover.

• Insert the Liebert IS-WEBRT3 Card into the bay.

• Secure the card with the supplied screws.

• Connect the card to your network with a CAT5 Ethernet
cable.

SET LIEBERT IS-WEBRT3 CARD
PASSWORD

• Insert the Liebert PSI-RT3 Software CD and install Liebert DeskPro-Net Util­ity on your computer.

• Start Liebert DeskPro-Net Utility by clicking on
Start>Programs>NetAgent>DeskPro-Net Utility. The software will
automatically find and list available Liebert IS-WEBRT3 cards.

• Double-click on a card in the list to launch it.

• Enter an Account (login name) and Password—Record the login and
password and save them in a safe place.

CONFIGURE LIEBERT IS-WEBRT3 CARD

• Highlight the card in the list and click Configure to change the card’s IP
address, subnet mask, and gateway settings (see your network administrator
for the settings).

TheLiebert IS-WEBRT3 card can be used with DHCP or BOOTP, where the sys­tem assigns an address, but this makes troubleshooting difficult.

• Liebert MultiLink™ will communicate with the Liebert IS-WEBRT3 card. The
software can be configured to shut down a computer system in response to util­ity power failure and the UPS’ battery backup time.

User Manual

This Quick Start Guide is designed to
give you the information you need to
install and configure the Liebert IS­WEBRT3 Card. A full user manual,
SL-52665, is available online at

www.liebert.com. Liebert recommends

that new users consult the user manual.

Web Support

The IS-WEBRT3 Card delivers Web
management and control to Liebert
equipment. All users on your network
will be able to view status information.
Control and configuration capabilities
are protected by a username and
password combination.
You can change the password from the
Web or from DeskPro-Net Utility.

Liebert MultiLink™ Support

Liebert MultiLink software, can be
downloaded at multilink.liebert.com

SNMP Support

The Liebert IS-WEBRT3 Card enables
SNMP management of Liebert PSI
equipment. To integrate the card into
your SNMP implementation, you will
need to compile the UPS MIB on your
network management station (NMS).
The UPS MIB is included in this
package on CD-ROM and supports both
Windows and Unix file formats.

Liebert Nform Support

Utilizing the SNMP and Web
technologies built into each of the
Intellislot Web cards, Liebert Nform
will centrally manage alarm
notifications to provide you with an easy
interface to access critical system
information.

A downloadable edition is available
online at nform.liebert.com

Technical Support/ Service

Web Site

www.liebert.com

Monitoring

800-222-5877
[e-mail]
Outside the US: 614-841-6755

Locations

United States

1050 Dearborn Drive
P.O. Box 29186
Columbus, OH 43229

SL-52660_REV01_07-08

Locations

Europe

Via Leonardo Da Vinci 8

Zona Industriale Tognana

35028 Piove Di Sacco (PD) Italy

[phone]

Fax: [phone]

Asia

7/F, Dah Sing Financial Centre

108 Gloucester Road, Wanchai

Hong Kong

852 25722201

Fax: [phone]